Fagor America RFA-244 DF, RFA-365 DF manual Electrical Connection

Page 13

For a situation where the appliance is between two cabinets and the anti-tip device cannot be fitted, we suggest securing the range by screwing through both sides of the cabinets into the sides of the cooker. The installation screws should be fitted as follows. Position the oven between the cupboards in its final position, then mark the location of the pilot hole inside the cupboard. Use a 3.5mm diameter drill bit to drill the pilot hole through the cupboard and both sides of the range.

Before drilling, check your measurements to ensure the pilot holes are located within the area specified in the installation diagram. A drilled hole in the side of the range, which is outside the specified area, may void the warranty. Inspect cabinets thoroughly before drilling to avoid damage to electrical wires or gas lines. Fix two 12 gauge x 40mm long self tapping screws through the pilot holes inside both cabinets and into the side of the range.

Note: Required screw length is based on cupboard thickness of 20mm, and gap between cupboard and range of 10mm.

Screw length could vary depending on cupboard material thickness and gap between range and cupboards.

Note: The screws must be accessible for removal.

2.4ELECTRICAL CONNECTION

WARNING! ELECTRICAL SHOCK HAZARD

Disconnect electrical power at the breaker box or fuse box before installing this appliance. Please make sure the unit is properly grounded for safety. Use copper conductors only. Failure to follow these instructions could result in serious injury or death.

CAUTION

Label all wires prior to disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation. Always verify proper operation after servicing.

The range is fitted with an approved 15 Amp flexible cord which must be connected to a correctly grounded power line. The manufacturer is not liable for any direct or indirect damage caused by faulty installation or connection. It is therefore necessary that all installation and connection operations are carried out by qualified personnel complying with the applicable local and general regulations.

The wire section on the cable must not be less than 1.5mm (3×1.5 cable). Use only the cables available at our service centers.

13

Image 13
Contents Installation Use Care Instructions Remarque Contents Page Thank YOU What to do if YOU Smell GAS Important SafeguardsPage Page Before Installation Installation & Electrical and GAS ConnectionType of GAS Installation Dimensions Installing the ANTI-TIP Stability Chain Electrical Connection Connection of the Feeding Cable to the Mains Ventilation GAS ConnectionManual SHUT-OFF Valve Flexible ConnectionsConversion to Different Types of GAS RFA-244 DF GAS Burner Data TablesSetting the Minimum Flame Final Checklist Finishing Your InstallationFinal Preparation Burner Layout Using the GAS CooktopMain Parts of the GAS Cooktop Recommendations Ignition and Operation of the BurnersBefore Using the Oven for the First Time Using the Oven and Practical TipsAdjusting the Clock Getting StartedCooking Program Selector Control PanelOperating the Oven Temperature SelectorBaking Tray AccesoriesDeep Tray Rotisserie Grill with Non-Tip Safety CatchSuggestions and Practical Tips for Baking Practical Advice and Cooking TableTable of Cooking Times Traditional Baking Time & Temperature ChartsFish Thawing Food Cleaning Range Cleaning and MaintenanceRange Exterior Helpful Tips Range InteriorUnhooking The Doors Replacing the Interior Light Bulb AccessoriesENERGY-SAVING Tips STOP/START Digital Timer Automatic Setting Timer FunctionsClock Timer Page Table DES Matières Page Message DE Bienvenue QUE Faire SI Vous Sentez UNE Odeur DE GAZ Instructions DE Sécurité ImportantesPage Page Avant L’INSTALLATION Installation ET Connexion Electrique ET DU GAZType DE GAZ Mesures Pour L’INSTALLATION Mise EN Garde Installation DE LA Chaine DE Stabilité ANTI-BASCULEMENTAvertissement ! Risque DE Choc Électrique Branchement ÉlectriqueConnexion DU Cable D’ALIMENTATION AU Réseau Vanne D’ARRÊT Manuelle Raccordement AU GAZRaccords Flexibles Conversion AUX Différents Types DE GAZ Brûleur Position Injecteur Gaz Pression Débit Tables DE Données DES Bruleurs À GAZRéglage D’UNE Flamme Minimum Liste DE Vérification Finale Finir L’INSTALLATIONDerniers Préparatifs Disposition DES Brûleurs Utilisation DE LA Table DE Cuisson AU GAZParties Principales DE LA Table DE Cuisson AU GAZ Allumage ET Fonctionnement DES Brûleurs RecommandationsAvant D’UTILISER LE Four Pour LA Première Fois Utilisation DU Four ET Conseils PratiquesRéglage de l’heure Nettoyage PréalablePanneau DE Contrôle Commande de Sélection des Fonctions de CuissonFonctionnement DU Four Commande de Sélection des TempératuresPlateau Pour Pâtisserie AccessoiresPlateau Profond Rôtisserie Grille Avec Butoir Sécurité AntichuteSuggestions et Conseils Pratiques Pour la Cuisson Conseils Pratiques ET Table DE CuissonTableau DES Temps DE Cuisson Poisson Décongélation Position PRÉ Aliments Nettoyage Nettoyage ET Entretien DE LA CuisinièreExtérieur de la Cuisinière Conseils Utiles 2. L’intérieur du CuisinièreDécrocher les portes Comment Remplacer LA Lampe DU Four Les AccessoiresConseils Pour Économiser DE L’ÉNERGIE Minuterie Numérique D’ARRÊT/MARCHE Fonctions DE Minuterie HorlogeRéglage Automatique Minuterie 01-14 REV013014