Aga Ranges 6-4 Series owner manual Fitting and Product Dimensions

FITTING AND PRODUCT DIMENSIONS

Any side wall above the cooker on either side shall be not less than 3” (75mm) horizontally from the cooker (Fig. 1).

Combustible surfaces over the top of the cooker must not be closer than 28” (711mm) and must not exceed 13” (400mm) in depth.

0” clearance to the back of the stove may be obtained when installing the appliance against a non-combustible wall or if the wall behind the stove is deemed combustible, then the minimum spacing from the back of the stove to nearest combustible wall is 6”.

A minimum clearance of 39 1/2” (1000mm) must be available at the front of the cooker to enable it to be serviced.

Any opening in the wall behind the appliance and in the floor under the appliance shall be sealed.

The cooker must stand on a firm and level surface, we recommend that any soft material such as linoleum is removed.

The vent slots in the back of the top plate must not be obstructed.

Fig. 1 DESN 512636 C

6