Aga Ranges 6-4 Series Cleaning & Caring for Your Cooker, KEY Lock, To Activate Keylock Function

AUTOMATIC COOKING CONTROL (continued)

KEY LOCK

If this mode is activated, a program can be set, but it will not be function, ie. ON and OFF times will be set, but the timer will not switch the ovens on.

TO ACTIVATE KEYLOCK FUNCTION

1.Ensure the timer is in manual mode (no active programs).

2.Hold the MINUTE TIMER button and COOK TIME button simultaneously for approximately 8 seconds. The display will read ON.

3.Press the plus + button. The display reads ‘OFF’ and the key symbol appears.

After approximately 5 seconds the time of day reappears next to the key symbol. The key lock is now activated.

TO DE-ACTIVATE KEYLOCK

1.Ensure the timer is in manual mode.

2.Hold the MINUTE TIMER button and COOK TIME button simultaneously for approximately 8 seconds. The display will read ‘OFF’.

3.Press the plus + button. The display reads or the key symbol disappears. After approximately 5 seconds the time reappears and the key lock is now deactivated.

CLEANING & CARING FOR YOUR COOKER

General

zAlways switch OFF at the mains before cleaning.

zUse as little water as possible.

zDo not use CAUSTIC CLEANING SOLUTIONS

zDo not use a steam cleaner to clean this cooker.

zIf milk or fruit juice or anything containing acid is spilt on the cooker, wipe it up immediately.

zWipe up any spills as they occur and transfer pans to other burners to continue cooking.

zClean off any condensation streaks on the front plate around the oven doors or the vitreous enamel maybe permanently discoloured.

zTAKE CARE NOT TO DAMAGE THE OVEN THERMOSTAT PHIAL OR THE HOTPLATE IGNITION ELECTRODES DURING CLEANING.

zAfter cleaning, ensure all parts are thoroughly dry before replacing.

zWhen re-fitting the burner caps and burner heads make sure that they are properly located.

zTHE FOLLOWING PARTS ARE NOT DISHWASHER SAFE: Aluminum burner heads (LHR, CF, RHR, RHF).

Moving the Cooker

The cooker is fitted with mobility rollers, two at the rear and two at the front.

The 6-4 Series is designed to stand on a flat and level surface, however, any unevenness may be overcome by adjusting the four levelling feet, one at each corner of the base plate. The adjusting screws are accessed by removing left and right hand hotplate castings. To raise the cooker turn screw clockwise, to lower turn screw counter-clockwise.

The rollers on the base of the cooker allow for positioning.

When the cooker is in the correct position the four levelling feet can be adjusted to level the cooker. THE FEET MUST BE LOWERED ENOUGH TO PREVENT THE COOKER ROLLING

OUT OF POSITION.

42