Turn on the power to the ice maker. Pour 8 oz. of Nickel-Safe Ice Machine Cleaner solution into the
water sump. Add 8 oz. of tap water. After about 5 minutes, press down the “Clean” button on the Control Box. (See figures here and on page 24.) The machine will run the Automatic Clean Mode.
Water sump
22
4.
2. Open the door and scoop out all of the ice cubes. Either discard them or save them in
an ice chest or cooler.
Control Box
3. Remove the 2 screws in the front cover and push for- ward to remove the front cover. Locate the control box. NOTES: Do not use too much force, as the wire leads connected to the power switch can be inadvertently disconnected.
Use care in the area of the control box. Do not expose it to moisture.
To drain
Nut of water-draining hole
Water line
Inlet water valve
Minerals that are removed from water during the freezing cycle will eventually form a hard scaly deposit in the water
system. Cleaning the system regularly helps
remove the mineral scale buildup. How
often you need to clean the system depends
upon how hard your water is or how
effective your filtration may be. With hard
water of 15 to 20 grains/gal. (4 to 5 grains/liter), you may need to clean the system as often as every 6 months.
1. Turn off power to the ice maker. Keep the ice maker connected to the water supply and drainpipe.
6. Wipe down the interior of the water sump with the de-scaling solution and warm water. Rinse thoroughly with clear water.
7. Reassemble the sprinkler arm, slideway and row of flake covers.
8. Perform steps 1, 3, 6, 7 and 8 of the Ice Making System Cleaning procedure below.
Ice Making System Cleaning