Franklin Industries, L.L.C FIM90, FIM120 user manual Before Calling for Service

TROUBLESHOOTING

Before Calling for Service

If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem persists, check the TROUBLESHOOTING GUIDE below and on the following page. The problem could be something very simple which can be solved without a service call.

Troubleshooting Guide

Problem	Possible Cause	Probable Correction
	The ice maker is unplugged.	Plug the ice maker in.
		Replace fuse. If it happens again, call
	The fuse is blown.	for service to check for a short circuit
The machine		in the ice maker.
doesn’t operate.	The ice maker power	Turn the ice maker power switch ON.
	switch is OFF.
	The ice storage bin is full of	Remove some ice; make sure the
	ice.	ice-full sensor is free of ice.
The water doesn’t	The water supply tap is	Turn on the water supply tap.
	turned off.
feed in after the ice
	The water supply line is not
maker starts.		Reconnect the water supply line.
	connected properly.
	The bin should fill up and
	the machine shut off in	Clean the condenser.
	9-14 hours. If not, the
	condenser may be dirty.
	The bin drain may be	Clean out the drain; check the
Machine makes	partially restricted.	installation.
ice, but ice storage	The airflow to the ice	Check the installation.
bin does not fill up	maker may be obstructed.
with ice.	The ambient temperature
	and water temperature are
	high, or machine is near	Check the installation.
	some heat source.

26