Whirlpool WRS950SIAE Style, Connect to Water Line, Connect to Refrigerator

Page 9

Connect to Water Line

IMPORTANT: If you turn the refrigerator on before the water line is connected, turn the ice maker OFF.

1.Unplug refrigerator or disconnect power.

2.Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3.Use a quarter-turn shutoff valve or the equivalent, served by a ¹⁄₂" copper household supply line.

NOTE: To allow sufficient water flow to the refrigerator, a minimum ¹⁄₂" size copper household supply line is recommended.

Connect to Refrigerator

Style 1

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

A

B

C

 

D

A. Bulb

C. Copper tubing (to refrigerator)

B. Nut

D. Household supply line (½" minimum)

4.Now you are ready to connect the copper tubing to the shutoff valve. Use ¹⁄₄" (6.35 mm) OD soft copper tubing to connect the shutoff valve and the refrigerator.

■Ensure that you have the proper length needed for the job. Be sure both ends of the copper tubing are cut square.

■Slip compression sleeve and compression nut onto copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

A B

C

A. Compression sleeve

C. Copper tubing

B. Compression nut

 

5.Place the free end of the tubing into a container or sink, and turn on main water supply to flush out tubing until water is clear. Turn off shutoff valve on the water pipe.

NOTE: Always drain the water line before making the final connection to the inlet of the water valve, to avoid possible water valve malfunction.

6.Bend the copper tubing to meet the water line inlet, which is located on the back of the refrigerator cabinet as shown. Leave a coil of copper tubing to allow the refrigerator to be pulled out of the cabinet or away from the wall for service.

A

B

C

D

A. Line to refrigerator

 

C. Ferrule (purchased)

B. Nut (purchased)

 

D. Supplied line from refrigerator

4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the plastic part that is attached to the inlet of the water valve.

3.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.

4.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

A

 

B

 

C

 

D

 

E

A. Tube clamp

D. Compression nut

B. Tube clamp screw

E. Valve inlet

C. Copper tubing

 

7.On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Refrigerator User Instructions Refrigerator Safety Installation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer Tools Needed Door Removal, Leveling and AlignmentReplace the Doors and Hinges Remove the wiring clip using a ¹⁄₄ hex-head socket wrench To Install the Handles Handle Installation and Removal Leveling and Door Closing Door AlignmentLocation Requirements To Remove the HandlesStyle 2 Slide-on Parts Included Door handles Water Supply Requirements Electrical RequirementsConnect Water Supply Recommended Grounding MethodStyle Connect to Water LineConnect to Refrigerator Install Air Filter Installing the Air Filter on some modelsInstalling the Filter Status Indicator on some models Install Produce Preserver Installing the Status Indicator on some models Using the ControlsAdjusting the Controls Refrigerator USEConvertible Drawer Temperature Control Condition Temperature AdjustmentCrisper Humidity Control Chilled Door Bin Water and Ice DispensersTo Dispense Water Standard To Dispense Water Measured Fill Units Default Minimum MaximumTo Dispense Ice Ice DispenserIce Maker and Storage Bin Turning the Ice Maker On/OffRemoving and Replacing Ice Storage Bin To Clean Your Refrigerator CleaningRefrigerator Care Water Filtration SystemTroubleshooting LightsRefrigerator Operation Temperature is too warm Temperature and MoistureIce and Water Humid room? Contributes to moisture buildupWater Filter Certifications AccessoriesWater Filtration System Performance Data SheetLimited Warranty Whirlpool Corporation Major Appliance WarrantyItems Excluded from Warranty This limited warranty does not coverSeguridad DEL Refrigerador Instrucciones Para EL Usuario DEL RefrigeradorInstrucciones DE Instalación Desempaque el refrigeradorAntes de tirar su viejo refrigerador o congelador Herramientas Necesarias Remoción, nivelación y alineamiento de las puertasVuelva a colocar las puertas y las bisagras Quite las puertasAlineamiento de las puertas Nivelación y cierre de las puertasPara instalar las manijas Cómo instalar y remover las manijasPara quitar las manijas Estilo 1 Tornillos opresoresRequisitos eléctricos Requisitos de ubicaciónRequisitos del suministro de agua Método de conexión a tierra recomendadoConexión del suministro de agua Suministro de agua de ósmosis inversaEstilo Cómo terminar la instalación Instalación del filtro de aireInstalación del preservador de Alimentos frescos Uso de los controles USO DE SU RefrigeradorNota Para el mejor desempeño, use siempre dos bolsas Para pedir repuestos, vea AccesoriosCondición Regulación DE LA Temperatura Cómo ajustar los controlesEncendido/Apagado del enfriamiento Características adicionales Fast Ice Hielo rápidoControl de temperatura del Cajón convertible Control de humedad del cajón Para verdurasDepósito enfriador de la puerta Despachadores de agua y hielo Para despachar agua estándarPara despachar agua Llenado medido Unidades Prefijado Mínimo Máximo Para despachar hieloSegundos y luego continúe haciendo ajustes El despachador de hieloFábrica de hielo y depósito Para encender y apagar la fábrica de hieloCómo quitar y volver a colocar el depósito de hielo Sistema de filtración de agua Luz de estado del filtro de aguaCómo cambiar el filtro de agua Limpieza Cuidado DE SU RefrigeradorLuces Para limpiar su refrigeradorFuncionamiento del refrigerador Solución DE ProblemasEl refrigerador no funciona Parece que el motor funciona excesivamenteHielo y agua Temperatura y humedadNota Esto es una indicación de baja presión de agua El despachador de hielo no funciona debidamenteLimpiador de acero inoxidable affresh† AccesoriosFiltro de agua Filtro de aireSistema de filtración de agua Hoja DE Datos DEL RendimientoExclusiones DE LA Garantía Garantía LimitadaEsta garantía limitada no cubre Exclusión DE Garantías ImplícitasWhirlpool Brand Home Appliances Sécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurInstructions Dinstallation Déballage du réfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Outillage Nécessaire Retrait, réglage de laplomb et alignement de la porteRéinstaller les portes et les charnières Enlever les portesImportant Ne pas retirer l’une des vis a Alignement des portes Nivellement et fermeture de la porteInstallation des poignées Installation et démontage des poignéesRetrait des poignées Style 1 Vis de blocageMéthode recommandée de mise à la terre Exigences demplacementSpécifications électriques Spécifications de l’alimentation en eauAlimentation en eau par osmose inverse Raccordement de la canalisation deauPression de leau Raccordement à une canalisation d’eauAchever l’installation Installation du filtre à airInstallation du sachet de conservation Pour produits frais Pour commander des sachets de rechange, voir Accessoires Utilisation des commandesUtilisation DU Réfrigérateur Retirer l’ancien témoinCondition Ajustement DE LA Température Ajustement des commandesRefroidissement On/Off marche/arrêt Caractéristiques supplémentaires Fast Ice glace rapideCommande de température dans Le tiroir convertible Réglage de lhumidité dans Le bac à légumesCompartiment fraîcheur dans la porte Distributeurs d’eau et de glaçons Distribution deau standardDistribution deau remplissage mesuré Distribution de glace Unités Par défaut Minimum MaximumLe distributeur de glaçons Machine à glaçons et bac Dentreposage Pour retirer et réinstaller le bac à glaçonsMise en marche/arrêt de la machine à glaçons La lampe du distributeurRemplacement du filtre à eau Système de filtration de leauTémoin lumineux de létat du filtre à eau Nettoyage Entretien DU RéfrigérateurLampes Nettoyage de votre réfrigérateurFonctionnement du réfrigérateur DépannageGlaçons et eau Température et humiditéLe réfrigérateur bascule et n’est pas stable Remarque Cela indique une faible pression de leauAccessoires Système de filtration d’eau Feuille DE Données SUR LA PerformanceGarantie Limitée Garantie DE Gros Appareil Ménager Whirlpool CorporationÉléments Exclus DE LA Garantie La présente garantie limitée ne couvre pasW10433428B EN/FR PN W10416734B
Top Page Image Contents