Whirlpool WRS950SIAE Remove the wiring clip using a ¹⁄₄ hex-head socket wrench

Page 5

Remove the Doors

WARNING

Electrical Shock Hazard

Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

1.Unplug refrigerator or disconnect power.

2.Open both doors to 90°. Remove the base grille by removing the two screws, then pulling out on the outside corners. See Graphic 1.

NOTE: The doors must only be opened to 90°. If they are opened all the way, the base grille will not come off.

3.Disconnect the water tubing, located behind the base grille on the freezer door side. The dispenser tubing runs through the door hinge, and must be disconnected in order to remove the door. See Graphic 2.

■Press the colored outer ring against the face of fitting and pull the water tubing free.

NOTE: Keep the water tubing connector attached to the tube that runs underneath the freezer. The door cannot be removed if the connector is still attached to the tube that runs through the door hinge.

4.Disconnect the wiring, located behind the base grille on the freezer door side. See Graphic 3.

■Remove the P-clamp using a ¹⁄₄" hex-head socket wrench. Remove the small wiring bundle from the P-clamp.

■Remove the wiring clip using a ¹⁄₄" hex-head socket wrench.

■Pull the electrical housing out from under the refrigerator. Disconnect the wiring plugs from the housing.

■Gently pull the large wiring bundle (with two white plugs) through the routing plate.

5.Close both doors and keep them closed until you are ready to lift them free from the cabinet.

6.Use a ³⁄₁₆" hex key to remove the top left hinge screws as shown. See Graphic 4.

IMPORTANT: Do not remove either screw A.

WARNING

Excessive Weight Hazard Use two or more people to lift the freezer door. Failure to do so can result in back or other injury.

7.Lift freezer door straight up off bottom hinge. See Graphic 5. The water tubing and wiring remain attached to the freezer door and pull through the bottom left hinge.

NOTE: This may require two people - one to lift the door and another to feed the water tubing and wiring through the hinge. Be sure the hole in the hinge is clear of obstructions, then gently pull one water tube through the hinge. (Avoid kinking the tube.) Next, gently pull the other water tube through the hinge, again avoiding kinks. Finally, gently pull the wiring bundle (including the grommet and wiring plugs) through the hinge.

IMPORTANT: Rest the door on its side on a soft, clean surface, such as a towel, blanket or piece of cardboard. This will help avoid damaging the door, water tubing and wiring.

8.Use a ³⁄₁₆" hex key to remove the top right hinge screws as shown. See Graphic 6.

IMPORTANT: Do not remove either screw A.

9.Lift the refrigerator door straight up off bottom hinge.

IMPORTANT: Rest the door on its side on a soft, clean surface, such as a towel, blanket or piece of cardboard. This will help avoid damaging the door.

10.It may not be necessary to remove the bottom hinges to move the refrigerator through a doorway. Both bottom hinges have similar construction.

■If necessary, use an internal star drive or a ³⁄₈" hex-head socket wrench to remove the bottom hinges. See Graphic 7.

IMPORTANT: The leveler brackets are mounted behind the hinges. If you remove the hinges, make sure that the leveler brackets are replaced when reinstalling the hinges.

Replace the Doors and Hinges

1.Replace both bottom hinges, if removed. Make sure that the leveler brackets are assembled behind the hinges. Tighten screws.

IMPORTANT: When the screws are tightened properly, there should not be any gaps between the refrigerator, leveler bracket and hinge.

NOTE: There are two wiring bundles that run underneath the freezer - a large bundle with a large grommet and two white plugs at the end, and a small bundle with a small grommet and one yellow plug at the end.

WARNING

Excessive Weight Hazard Use two or more people to lift the freezer door. Failure to do so can result in back or other injury.

2.Before replacing the freezer door on the bottom left hinge, feed the small wiring bundle through the hinge. Assistance may be needed.

IMPORTANT: Do not feed the large wiring bundle through the hinge. This bundle is intended to run directly from the door to the connections beneath the freezer. Forcing the large bundle through the hinge may damage the door and/or the wiring, and will keep the door from closing properly.

3.Feed both water tubes through the bottom left hinge, then replace the freezer door on the hinge. Assistance may be needed.

NOTE: Provide additional support for the doors while the top hinges are being replaced. Do not depend on the door magnets to hold the doors in place while you are working.

4.Align and replace the top left hinge as shown. See Graphic 4. Tighten screws.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Refrigerator User Instructions Refrigerator Safety Before You Throw Away Your Old Refrigerator or Freezer Installation InstructionsUnpack the Refrigerator Tools Needed Door Removal, Leveling and AlignmentReplace the Doors and Hinges Remove the wiring clip using a ¹⁄₄ hex-head socket wrenchTo Install the Handles Handle Installation and RemovalLeveling and Door Closing Door AlignmentStyle 2 Slide-on Parts Included Door handles Location RequirementsTo Remove the Handles Water Supply Requirements Electrical RequirementsConnect Water Supply Recommended Grounding MethodConnect to Refrigerator StyleConnect to Water Line Installing the Filter Status Indicator on some models Install Air FilterInstalling the Air Filter on some models Install Produce Preserver Installing the Status Indicator on some models Using the ControlsAdjusting the Controls Refrigerator USECrisper Humidity Control Convertible Drawer Temperature ControlCondition Temperature Adjustment To Dispense Water Standard Chilled Door BinWater and Ice Dispensers To Dispense Water Measured Fill Units Default Minimum MaximumTo Dispense Ice Ice DispenserRemoving and Replacing Ice Storage Bin Ice Maker and Storage BinTurning the Ice Maker On/Off To Clean Your Refrigerator CleaningRefrigerator Care Water Filtration SystemRefrigerator Operation TroubleshootingLights Temperature is too warm Temperature and MoistureIce and Water Humid room? Contributes to moisture buildupWater Filter Certifications AccessoriesWater Filtration System Performance Data SheetLimited Warranty Whirlpool Corporation Major Appliance WarrantyItems Excluded from Warranty This limited warranty does not coverSeguridad DEL Refrigerador Instrucciones Para EL Usuario DEL RefrigeradorAntes de tirar su viejo refrigerador o congelador Instrucciones DE InstalaciónDesempaque el refrigerador Herramientas Necesarias Remoción, nivelación y alineamiento de las puertasVuelva a colocar las puertas y las bisagras Quite las puertasAlineamiento de las puertas Nivelación y cierre de las puertasPara instalar las manijas Cómo instalar y remover las manijasPara quitar las manijas Estilo 1 Tornillos opresoresRequisitos eléctricos Requisitos de ubicaciónRequisitos del suministro de agua Método de conexión a tierra recomendadoEstilo Conexión del suministro de aguaSuministro de agua de ósmosis inversa Cómo terminar la instalación Instalación del filtro de aireInstalación del preservador de Alimentos frescos Uso de los controles USO DE SU RefrigeradorNota Para el mejor desempeño, use siempre dos bolsas Para pedir repuestos, vea AccesoriosCondición Regulación DE LA Temperatura Cómo ajustar los controlesEncendido/Apagado del enfriamiento Características adicionales Fast Ice Hielo rápidoDepósito enfriador de la puerta Control de temperatura del Cajón convertibleControl de humedad del cajón Para verduras Para despachar agua Llenado medido Despachadores de agua y hieloPara despachar agua estándar Unidades Prefijado Mínimo Máximo Para despachar hieloSegundos y luego continúe haciendo ajustes El despachador de hieloCómo quitar y volver a colocar el depósito de hielo Fábrica de hielo y depósitoPara encender y apagar la fábrica de hielo Cómo cambiar el filtro de agua Sistema de filtración de aguaLuz de estado del filtro de agua Limpieza Cuidado DE SU RefrigeradorLuces Para limpiar su refrigeradorFuncionamiento del refrigerador Solución DE ProblemasEl refrigerador no funciona Parece que el motor funciona excesivamenteHielo y agua Temperatura y humedadNota Esto es una indicación de baja presión de agua El despachador de hielo no funciona debidamenteLimpiador de acero inoxidable affresh† AccesoriosFiltro de agua Filtro de aireSistema de filtración de agua Hoja DE Datos DEL RendimientoExclusiones DE LA Garantía Garantía LimitadaEsta garantía limitada no cubre Exclusión DE Garantías ImplícitasWhirlpool Brand Home Appliances Sécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions DinstallationDéballage du réfrigérateur Outillage Nécessaire Retrait, réglage de laplomb et alignement de la porteImportant Ne pas retirer l’une des vis a Réinstaller les portes et les charnièresEnlever les portes Alignement des portes Nivellement et fermeture de la porteInstallation des poignées Installation et démontage des poignéesRetrait des poignées Style 1 Vis de blocageMéthode recommandée de mise à la terre Exigences demplacementSpécifications électriques Spécifications de l’alimentation en eauAlimentation en eau par osmose inverse Raccordement de la canalisation deauPression de leau Raccordement à une canalisation d’eauAchever l’installation Installation du filtre à airInstallation du sachet de conservation Pour produits frais Pour commander des sachets de rechange, voir Accessoires Utilisation des commandesUtilisation DU Réfrigérateur Retirer l’ancien témoinCondition Ajustement DE LA Température Ajustement des commandesRefroidissement On/Off marche/arrêt Caractéristiques supplémentaires Fast Ice glace rapideCompartiment fraîcheur dans la porte Commande de température dans Le tiroir convertibleRéglage de lhumidité dans Le bac à légumes Distribution deau remplissage mesuré Distributeurs d’eau et de glaçonsDistribution deau standard Le distributeur de glaçons Distribution de glaceUnités Par défaut Minimum Maximum Machine à glaçons et bac Dentreposage Pour retirer et réinstaller le bac à glaçonsMise en marche/arrêt de la machine à glaçons La lampe du distributeurTémoin lumineux de létat du filtre à eau Remplacement du filtre à eauSystème de filtration de leau Nettoyage Entretien DU RéfrigérateurLampes Nettoyage de votre réfrigérateurFonctionnement du réfrigérateur DépannageGlaçons et eau Température et humiditéLe réfrigérateur bascule et n’est pas stable Remarque Cela indique une faible pression de leauAccessoires Système de filtration d’eau Feuille DE Données SUR LA PerformanceGarantie Limitée Garantie DE Gros Appareil Ménager Whirlpool CorporationÉléments Exclus DE LA Garantie La présente garantie limitée ne couvre pasW10433428B EN/FR PN W10416734B
Top Page Image Contents