Cycle Selection Charts, Canceling a Cycle

■Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed.

■Run your dishwasher with full loads. Run a rinse cycle after meals until the dishwasher is full.

■If your home is equipped with a water softener, you may want to avoid starting the dishwasher during the regeneration of the softener, since this may contribute to poor wash performance.

Cycle Selection Charts

Select the wash cycle and options desired and press START/ RESUME. The dishwasher starts filling once you press START/ RESUME, unless you select a delay wash. You can select an option as the machine is filling.

After a wash cycle, the dishwasher remembers the options used and uses the same options in the next wash cycle unless new options are selected or Cancel/Drain is selected.

A “●” shows what steps are in each cycle. Your model may have some or all of the cycles shown.

Temperatures indicate where extra heat is added.

Water usage is shown in U.S. gallons/liters.

These models meet the ENERGY STAR® guidelines for energy efficiency.

Cycle time includes dry time. An asterisk ( * ) by the cycle time indicates the cycle time might be longer depending on the temperature of the water entering the dishwasher. The cooler the water, the longer the cycle time. If the water is already hot enough, the cycle time will be as shown.

Pots & Pans

Use this cycle for hard-to-clean, heavily soiled pots, pans, casseroles, and regular tableware.

Use both detergent dispenser sections.

Pre-	Rinse	Main	Rinse	Purge†	Final	Dry	Time	Water
Wash		Wash			Rinse		(min)	Usage
								(gal/L)

140°F		140°F			140°F		87*	8.6/32.6
(60°C)		(60°C)			(60°C)
●		●	●		●	●

Normal Wash

Use this cycle for loads with normal amounts of food soil. (The energy-usage label is based on this cycle.)

Use covered detergent dispenser section.

Pre-	Rinse	Main	Rinse	Purge†	Final	Dry	Time	Water
Wash		Wash			Rinse		(min)	Usage
								(gal/L)

					140°F		61*	4.8/18.0
					(60°C)
		●		●	●	●

Light Wash

Use this cycle for prerinsed or lightly soiled loads.

Use covered detergent dispenser section.

Pre-	Rinse	Main	Rinse	Purge†	Final	Dry	Time	Water
Wash		Wash			Rinse		(min)	Usage
								(gal/L)

					140°F		58*	4.8/18.0
					(60°C)
		●		●	●	●

Rinse Only

Use this cycle for rinsing dishes, glasses, and silverware that will not be washed right away.

Do not use detergent with this cycle.

Pre-	Rinse	Main	Rinse	Purge†	Final	Dry	Time	Water
Wash		Wash			Rinse		(min)	Usage
								(gal/L)

			●				10	2.2/10.0
			●

†A small amount of water runs through the pump to remove soil particles.

Heavy Wash

Use this cycle for loads with heavy food soil.

Use both detergent dispenser sections.

Pre-	Rinse	Main	Rinse	Purge†	Final	Dry	Time	Water
Wash		Wash			Rinse		(min)	Usage
								(gal/L)

					140°F		72*	6.9/26.1
					(60°C)
●		●		●	●	●

Canceling a Cycle

Anytime during a cycle, press CANCEL/DRAIN. Cancel/Drain glows. The dishwasher pauses for about 5 seconds and starts a 2-minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press CANCEL/DRAIN again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press CANCEL/DRAIN before starting the dishwasher to clear all options and cycles.