Adding Items During a Cycle, Canceling a Cycle

	Use this cycle for rinsing		Do not use
	dishes, glasses, and		detergent
	silverware that will not be		with this
	washed right away.		cycle.
Pre-	Rinse Main Rinse Purge†	Final	Dry	Time	Water
Wash	Wash	Rinse		(min)	Usage
					(gal/L)
	●			10	2.2/10.0
	●

†A small amount of water runs through the pump to remove soil particles.

††Series 940 and 960 only.

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open the door and check the detergent dispenser. If the main wash section is still closed, you can add items.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door. If the main wash detergent dispenser is still closed, add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle after about a 5 second pause.

Canceling a Cycle

Anytime during a cycle, press

CANCEL/DRAIN glows. The dishwasher pauses for about 5 seconds and starts a 2 minute drain (if needed). Let the dishwasher drain completely. The light goes off when the dishwasher finishes the drain.

To stop the drain

You can press Cancel/Drain again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press Cancel/Drain before starting the dishwasher to clear all options and cycles.

Changing a Cycle or Setting

During the first minute of a cycle

Press a new cycle and/or options.

After the first minute of a cycle

1.Press

CANCEL/DRAIN glows. The dishwasher pauses for 5 seconds and starts a 2 minute drain (if needed). Let the dishwasher drain completely.

2.Check the detergent dispensers. If the main wash cup has opened and the detergent washed away, refill the cups as needed.

3.Close the door.

4.Press a new cycle and/or options.

Option Selections

You can customize your cycles by pressing an option. If you change your mind, press the option again to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

After a wash cycle, the dishwasher remembers the options used and uses the same options in the next wash cycle, unless you select new options or press Cancel/Drain.

POWERSCOUR™ feature (on some models)

Select this high-temperature option for improved cleaning of heavily soiled dishes. Selecting this option adds heat, water and time to the wash cycle. Heating the water helps improve washing results.

The Pots-N-Pans cycle, with the POWERSCOUR feature, is recommended for baked-on soil.

NOTE: The POWERSCOUR feature is an option with Pots-N- Pans, Heavy and Normal.

High Temp Wash (on some models)

Select this option to heat the water to 140°F (60°C) in the main wash. This option adds heat and wash time. Heating the water helps improve washing results.

NOTE: The Pots-N-Pans and Heavy cycles automatically use this option. High Temp Wash is an option with Normal, Low Energy, Low Energy/China and Crystal/China.

Air Dry

Select this option to dry dishes without heat and save energy. The dishes take longer to dry and some spotting can occur.