LOCATION OF APPLIANCE
This appliance must not be installed in a
L.P.G. cookers MUST NOT be installed below ground level, i.e in a basement, or aboard any boat, yacht or other vessel.
INSTALLATION
1.PARTS REQUIRED
The loose hotplate parts are packed in the polystyrene fitment on the top of the hotplate. The grill pan, grill pan handle, fixing screws and splashplate fixing screws can be found in the oven pack which is located in the oven compartment. The grill pan requires assembly before use (see Fig. 1).
2.GRILL ASSEMBLY
The two splashplate screws marked A (see Fig. 2a) should be screwed into the back of the appliance about halfway in. Engage the keyhole slots in the splashback behind the two screws taking care not to trap the H.T. wire (see Fig. 2b).
Insert the four splashplate screws marked B (see Fig. 2b).
Tighten 6 off splashplate screws (see Fig. 2b).
Connect the grill supply union at the back of the appliance and pull the grill H.T. lead through the opening in the splashplate. Feed lead through the hole in the top right hand side of the splashplate
and connect on to the grill electrode. (see Fig. 2b). | Fig.2b |
| |
Fig.2a |
|
|
43