Frigidaire FGGF3054MB, FGGF3054MF, FGGF3054MW Probe error message, Probe Too Hot message

Page 23

Probe (cont’d)

Fig. 1

Probe error message:

If the error message "Prob ERR" displays (Fig. 1), check to be sure that the probe connector is fully inserted into the receptacle. If the probe is fully inserted in the receptacle and the error message remains displayed, the probe may be defective and need replaced.

When "Prob ERR" displays, the oven control will not permit any oven feature to activate until corrected or the probe is removed. If the error message continues, remove the probe from the receptacle and oven.

"Probe Too Hot" message:

When the message "Prob" ... "Too"... "Hot" ... flashes in the display, the probe sensor temperature has exceeded 250°F (121°C). If the probe is not removed this message may continue until the sensor reaches 300°F (149°C) or higher, at which time the oven will automatically turn OFF and display "Prob ERR" message.

This message may have been generated if the probe sensor is exposed to direct oven heat or the food internal temperature is over 250°F (121°C). Be sure the probe sensor is fully covered by the food or if the food is done, press cancel and remove food and probe from the oven.

handle

probe cable

handle

probe sensor

Fig. 2

SETTING OVEN CONTROLS

NOTES

•During the cooking process the internal food temperature will display by default. To review the

target temperature press the keypad once.

After 6 seconds the display will revert back to the internal food temperature.

•To assure temperature accuracy, do not remove the probe from the food or receptacle until the desired internal temperature is met.

•If the probe is active and the probe is removed from the receptacle only, the probe feature will cancel but the oven will continue to cook.

•If the probe is active and the probe is removed from the food only, the probe feature will remain active, but the displayed internal food temperature may no longer be reliable. This may eventually generate a "Probe Too Hot" message.

•The oven will automatically turn OFF if the probe sensor reaches 300°F (149°C) or more.

•The probe feature cannot be set with broil or self- clean.

•To change the target temperature while cooking,

press the

keypad once. Use the numeric

keypads to change the target temperature. Press the start keypad to accept any change.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Use&Care Product Record and Registration ContentsTip Over Hazard DefinitionsImportant Safety Instructions Important Safety Notice Important Instructions for Using Your OvenConversion to Liquefied Petroleum Gas Grounding InstructionsOven rack stop Before Setting Oven ControlsOven vent location Oven racksBaking layer cakes with 1 or 2 oven racks Types of oven racksAir circulation in the oven To assemble the Effortless Oven Rack system Effortless Oven Rack systemSet proper burner flame size Before Setting Surface ControlsCorrect flame Setting Incorrect Flame setting Cookware material typesBefore first use Check for proper burner cap placementUsing the griddle Do not clean griddle in the dishwasherHome Canning Setting Surface ControlsSetting surface controls Setting a surface burnerOven Control Functions Minimum & maximum control settingsFeature Min. temp. /time Max. temp. /time Setting 12 or 24 hour display mode Setting Oven ControlsSetting the clock Setting oven lock Changing oven temperature display modeSetting for audible or silent keypad operation Quick preheat TimerTo set the timer for 5 minutes Step Press Press timer onoff Add a minuteBake time To set bake with oven temperature of 425F Step PressWhen the set bake time runs out BakeDelay start Convect roast all models ConvectConvect bake Press convect convert Convect convertProbe Probe cont’d Proper probe placement in foodFresh beef, veal, lamb Usda recommended minimum internal cooking temperaturesReceptacle probe Connector handle To set probe Ground meat & meat mixturesProbe Too Hot message Probe error messageClose the oven door Suggested broil settings table gas ovenBroil To set broil Step PressTo set oven for keep warm Step Press Press keep warm Setting pizza featureSetting keep warm To set the pizza feature Step PressOperating the oven light Adjusting the oven temperatureRestoring to factory default settings To Set the Sabbath Feature for use on To Set the Sabbath Feature cont’d Clean Do not SELF-CLEANINGPreparing for self-clean Read before starting self-cleanWhen the self-clean cycle is done Read before starting self-clean cont’dSetting a self-clean cycle Example To start an immediate self-clean cycle Step PressStarting another self-clean after cancellation Setting a delay start self-clean cycleIf it becomes necessary to cancel self-clean Restarting a self-clean cycle after a power outageCleaning recommendation table Care & CleaningCleaning the cooktop and surface burners Replacing interior oven light Aluminum foil and oven linersAluminum foil and oven liners cont’d To replace oven door Removing and replacing the lift-off oven doorTo remove oven door Oven Controls section Problem Possible Causes SolutionsBlock the oven vent area when cooking Setting Oven Controls sectionSolutions to common problems Before YOU Call Under Self-cleaning Problem Possible Causes Solutions Bake or self-cleanPut water or flour on the fire! Flour may be explosive Setting Surface ControlsExclusions This warranty does not cover the following Major Appliance Warranty

FGGF3054MB, FGGF3054MW, FGGF3054MF specifications

The Frigidaire FGGF3054 series, which includes the FGGF3054MF, FGGF3054MW, and FGGF3054MB models, represents a blend of modern design, innovative technology, and user-friendly features tailored for contemporary kitchens. These freestanding gas ranges stand out for their versatility and performance, making them an ideal choice for both everyday cooking and elaborate meal preparations.

One of the standout features of these models is their powerful 5-burner cooktop, which includes a high-efficiency burner designed to deliver rapid heat for quick boiling, while the lower-powered burners are ideal for simmering sauces or keeping meals warm. The ranges also feature continuous grates that allow for easy movement of pots and pans across different burners, enhancing convenience during cooking.

The ovens in the FGGF3054 series are equipped with advanced technologies aimed at improving cooking results. The Even Baking Technology ensures consistent heat distribution throughout the oven, resulting in perfectly baked goods every time. The self-cleaning function is another notable feature, allowing users to effortlessly maintain a clean oven without the need for manual scrubbing.

A significant aspect of the design is the professional-level look and feel, characterized by a stainless steel finish available in multiple colors, including sleek black and classic white options. The control panel is intuitive and user-friendly, featuring easy-to-read knobs and a large digital display that enhances the overall cooking experience.

Additionally, the models come with a large oven capacity, which is particularly beneficial for preparing family-sized meals or for entertaining. The range's storage drawer offers extra space for cookware, contributing to an organized kitchen environment.

Safety features are also prioritized in the Frigidaire FGGF3054 series. The ovens are equipped with a flame failure device, ensuring that gas flow is halted if the flame is extinguished, thereby providing peace of mind for users.

Overall, the Frigidaire FGGF3054MF, FGGF3054MW, and FGGF3054MB gas ranges combine style, practicality, and advanced cooking technology, making them reliable appliances for any home chef looking to elevate their culinary skills. With their blend of performance and aesthetic appeal, these ranges are designed to fit seamlessly into modern cooking spaces.
Top Page Image Contents