Operating Instructions Safety Instructions
Care and cleaning of the range.
Painted Surfaces
| Painted surfaces include the door, | Do not use commercial oven cleaners, |
| top of the control panel and the drawer | cleaning powders, steel wool or harsh |
| front. Clean these with soap and water or | abrasives on any painted surface. |
| a vinegar and water solution. |
|
|
| |
Roasting rack | Oven Racks and Convection Roasting Rack | |
| Clean the oven racks and the convection | NOTE: The oven racks and convection roasting |
Oven rack | roasting rack with an abrasive cleanser or | rack may be cleaned in the |
| steel wool. After cleaning, rinse the racks | However, the oven racks will darken in color, |
with clean water and dry with a clean | lose their luster and become hard to slide if | |
cleaned during the | ||
cloth. | ||
| ||
| To make the oven racks slide more easily, | |
| apply a small amount of cooking oil to a | |
| paper towel and wipe the edges of the | |
| oven racks with the paper towel. |
Consumer Support Troubleshooting Tips Care and Cleaning
ReceptacleSocket
Bulb
Screen
Tab
Glass cover
Oven Light Bulbs
NOTE: The glass cover should be removed only when cold. Wearing latex gloves may offer a better grip.
CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the oven at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool completely.
For your safety, do not touch a bulb with bare hands or a damp cloth. It can also shorten the bulb life.
To remove:
Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket.
Using gloves or a dry cloth, remove the bulb by pulling it straight out.
To replace:
Use a new 130-volt Halogen bulb, not to exceed 50 watts.
Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers.
Receptacle
Use gloves or cloth
Push the bulb straight into the receptacle all the way. Then replace the screen.
NOTE: The screen must be replaced or the life of the bulb will be reduced.
Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.
For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.
Reconnect electrical power to the oven.
44