GE JGB3000, JGB3001 Using the oven controls, Safety Instructions, Care, Installation Instructions

Safety Instructions

Operating Instructions

Cleaning

Using the oven controls.

Throughout this manual, features and appearance may vary from your model.

Oven Control, Clock and Timer Features and Settings (on some models)

Care and

Installation Instructions

Bake/Temp Recall Pad

Touch this pad to select the bake function.

Bake Light

Flashes while in edit mode—you can change the oven temperature at this point. Glows when the oven is in bake mode.

Start/On Pad

Must be touched to start any cooking or cleaning function.

Display

Shows the time of day, oven temperature, whether the oven is in the bake, broil or self-cleaning mode and the times set for the timer or automatic oven operations. The display will show PRE while preheating. When the oven reaches the selected temperature, the oven control will beep and the display will show the oven temperature.

Kitchen Timer On/Off Pad

Touch this pad to select the timer feature.

Then press the + and – pads to adjust the timer.

Timer Light

Flashes while in edit mode—you can change the set time at this point. Glows when the timer has been activated. Flashes again when the time has run out until the control is reset.

Clock Pad

To set the clock, press this pad twice and then press the + and – pads. The time of day will flash in the display when the oven is first turned on.

Start Time Pad (on some models)

Use along with the Cooking Time or Self Clean pads to set the oven to start and stop automatically at a time you set.

Troubleshooting Tips

Consumer Support

	If “F–” and a number or letter flash in the display
	and the oven control signals, this indicates a function
	error code.
	If your oven was set for a timed oven operation
	and a power outage occurred, the clock and all
	programmed functions must be reset.
	The time of day will flash in the display when there
	has been a power outage. Reset the clock.
	If the function error code appears during the
	self-cleaning cycle, check the oven door latch. The
	latch handle may have been moved, even if only
	slightly, from the latched position. Make sure the
	latch is moved to the right as far as it will go.
	Touch the Clear/Off pad. allow the oven to cool
	for one hour. Put the oven back into operation.
10	If the function error code repeats, disconnect
	the power to the range and call for service.

Start Time Light

Flashes while in edit mode—you can change the start time at this point. Glows when the function has been activated.

Cooking Time Pad (on some models)

Touch this pad and then touch the + or – pads to set the amount of time you want your food to cook. The oven will shut off when the cooking time has run out.

Cooking Time Light

Flashes while in edit mode—you can change the set time at this point. Glows when the function has been activated. Flashes again when the time has run out until the control is reset.