GE JGB3000 How to Delay the Start of Cleaning on some models, After a Clean Cycle on some models

Page 25

GEAppliances.com

The oven door must be closed and all controls set correctly for the cycle to work properly.

How to Delay the Start of Cleaning (on some models)

You can set the oven control to delay-start

Change the Start Time by touching the + or –

the oven, clean for a specific length of time

pads. The start time will appear in the display.

and then turn off automatically.

 

 

Touch the Start/On pad.

 

 

Make sure the clock shows the correct time

 

 

 

The self-clean cycle will automatically begin

of day.

at the time set.

 

Safety Instructions

Follow the directions in the Before a Clean Cycle section.

Latch the door.

NOTE: Never force the latch. If the oven is too hot, you will not be able to slide the latch. Allow the oven to cool.

Touch the Self Clean pad.

Touch the + or – pads to set the Clean Time.

The Clean Time is preset for 4 hours and

20 minutes. You can change the Clean Time to any time between 3 and 5 hours, depending on the amount of soil in your oven. If a different Clean Time is desired, touch the + or – pads until the desired Clean Time is displayed.

Touch the Start Time pad.

While the oven is self-cleaning, you can touch the Clock pad to display the time of day. To return to the clean countdown, touch the Self Clean pad.

The oven shuts off automatically when the clean cycle is complete, and 0:00 will flash in the display.

Slide the latch handle to the left as far as it will go and open the door.

Care and Cleaning

To Stop a Clean Cycle (on some models)

Touch the Clear/Off pad.

Wait until the oven has cooled below the locking temperature to unlatch the door. You will not be able to open the door right away unless the oven has cooled below the locking temperature.

Installation Instructions

After a Clean Cycle (on some models)

You cannot set the oven for cooking until the oven is cool enough for the door to be unlatched.

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap-filled scouring pad and rinse thoroughly with a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

nYou cannot set the oven for cooking until the oven is cool enough for the door to unlock.

nWhile the oven is self-cleaning, you can touch the Clock pad to display the time of day. To return to the clean countdown, touch the Cooking Time pad.

nIf the racks become hard to slide, apply

a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven racks with the paper towel.

TipsTroubleshooting Consumer Support

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Write the model and serial numbers here Model # Serial # 49-85177 04-2010 GEDetails before attempting to install Be secured by a properly installed anti-tip bracket. SeeTo reduce the risk of tipping the range, the range must Range within 4 inches. If it does not, the bracket must beGEAppliances.com IMPORTaNT SaFeTY NOTICeAppliance as a space heater to heat or SURFaCe BURNeRS Operating Instructions Cook MeaT aND Poultry THOROUgHLY…ELeCTRIC WaRMINg DRaWeR on some models OperatingInstructions Care and CleaningSafety Using the gas surface burnersCare and Cleaning Installation Instructions Troubleshooting TipsTop-of-Range Cookware Case of Power FailureCare Safety Instructions Using the oven controlsInstallation Instructions CareOr temperature by larger amounts Safety InstructionsTouch this pad to turn the oven light on or off Touch this pad to select the broil functionBefore you begin… Troubleshooting TipsOven Vent Care and Cleaning Installation Instructions Using the upper ovenSupport Place the meat or fish on a broiler grid in a broiler pan How to Set the Oven for BroilingHi Broil To change to Lo Broil, touchCleaning Using the clock and timer. on some modelsTo Set the Timer To Set the ClockTo Cancel the Timer To Reset the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopIf you wish to turn OFF this feature, follow the steps below Special features of your oven control. on some modelsHow to Set for Regular Baking/Roasting Using the Sabbath feature. on some modelsCare and Cleaning Installation Instructions Designed for use on the Jewish Sabbath and HolidaysTouch the Clear/Off pad How to Exit the Sabbath FeatureInstallation Troubleshooting InstructionsTips Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat on some models To Adjust the Thermostat on models with an Oven Temp KnobWhen Using the Warming Drawer Using the warming drawer. on some modelsOn Signal Light Push and turn the control knob to any desired settingTo Crisp Stale Items Temperature Selection ChartTo Warm Serving Bowls and Plates Before a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning ConsumerTo Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Operating Care and cleaning of the rangeBurner Grates BurnersStandard Twin Burner Assemblies on some models Instructions InstallationBurner Caps and Heads Operating Instructions Tips TroubleshootingCooktop Surface Oven Air VentsLift-Off Oven Door To clean the inside of the doorOven Bottom Oven frame, pull them back outRemovable Storage Drawer on some models Removable Kick Panel on some modelsRemovable Warming Drawer on some models Lower Control Panel Front Manifold Panel and Knobs Oven Light ReplacementOven Racks Do not remove any screws to remove the coverTooLS yoU wILL Need FoR yoUR SAFETyMaterials yoU MAy Need Gas line shut-off valveInstallation Instructions For models JGB3000, JGB3001, JGB281, JGB300, JGB400 DIMENSIoNS and Clearances28 to 281⁄4 PRoVIDE ADEqUATE GAS SUPPLy LoCATIoNCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Electrical CoNNECTIoNS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit Seal the oPENINGS Check oPERATIoN oF Surface BurnersWith LP gas, some yellow tipping on outer cones is normal Check oPERATIoN oF oVEN Burners Adjust the Bake and BRoILOther WHEN ALL HooKUPS are CoMPLETED Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…High to set a self-clean operation Oven will not self-clean Oven temperature is tooFood does not bake Oven controls improperly set Or roast properly Rack position is incorrectDuring self-clean cycle Self-clean light on Oven Temp knob has notDoor appears Self-cleaning cycle has been During the self-cleaning cycleDisplay goes blank Fuse in your home may be Power outage Power outage or surgeUnable to get Oven control pads were Display to show SF Not touched properlyLimited Time Offer! Free Shipping AccessoriesWhat GE Will Not Cover GE Will ReplaceFor The Period Warrantor General Electric Company. Louisville, KYWhat Mabe Will Not Cover Mabe Will ReplaceWarrantor Mabe Canada Inc Burlington, Ontario Consumer Support Schedule Service
Top Page Image Contents