GE JGB281 Display goes blank Fuse in your home may be, Unable to get Oven control pads were

Page 48

Safety Instructions

Consumer Support Tips Instructions Care and Cleaning Instructions

Troubleshooting InstallationOperating

Before you call for service…

Troubleshooting Tips

Problem

 

Possible Causes

What To Do

 

 

 

 

Display goes blank

 

A fuse in your home may be

• Replace the fuse or reset the circuit breaker.

(on some models)

blown or the circuit breaker

 

 

 

tripped.

 

 

 

 

 

 

 

The clock is turned off so that it

• See the Using the clock and timer section.

 

 

does not show in the display.

 

 

 

 

 

Display flashes

 

Power failure.

• Reset the clock.

(on some models)

 

 

 

 

 

 

 

Unable to get the

 

oven control pads were

• The Bake and Broil Hi/Lo pads must be touched at

display to show “SF”

 

not touched properly.

the same time and held for 3 seconds.

(on some models)

 

 

 

 

 

 

 

Power outage,

 

Power outage or surge.

• Reset the clock. If the oven was in use, you must reset

clock flashes

 

 

it by touching the Clear/Off pad, setting the clock and

(on some models)

 

 

resetting any cooking function.

 

 

 

 

“Burning” or “oily” odor

 

This is normal in a new oven

• To speed the process, set a self-clean cycle for a

emitting from the vent

 

and will disappear in time.

minimum of 3 hours. See the Using the self-cleaning

 

 

 

oven section.

 

 

 

 

Strong odor

 

An odor from the insulation

• This is temporary.

 

 

around the inside of the oven

 

 

 

is normal for the first few times

 

 

 

the oven is used.

 

 

 

 

 

Fan noise

 

A cooling fan may automatically

• This is normal. The cooling fan will turn off and on.

 

 

turn on and off to cool

 

 

 

internal parts.

 

 

 

 

 

Drawer does not slide

 

The drawer is out of alignment.

• Fully extend the drawer and push it all the way in.

smoothly or drags

 

 

See the Care and cleaning of the range section.

 

 

 

 

 

 

Drawer is overloaded or load

• Reduce weight. Redistribute drawer contents.

 

 

is unbalanced.

 

48

Image 48
Contents 49-85177 04-2010 GE Write the model and serial numbers here Model # Serial #Be secured by a properly installed anti-tip bracket. See Details before attempting to installTo reduce the risk of tipping the range, the range must Range within 4 inches. If it does not, the bracket must beIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS Cook MeaT aND Poultry THOROUgHLY… Operating InstructionsOperatingInstructions Care and Cleaning ELeCTRIC WaRMINg DRaWeR on some modelsUsing the gas surface burners SafetyCare and Cleaning Installation Instructions Troubleshooting TipsCase of Power Failure Top-of-Range CookwareCare Using the oven controls Safety InstructionsInstallation Instructions CareSafety Instructions Or temperature by larger amountsTouch this pad to turn the oven light on or off Touch this pad to select the broil functionTroubleshooting Tips Before you begin…Oven Vent Using the upper oven Care and Cleaning Installation InstructionsSupport How to Set the Oven for Broiling Place the meat or fish on a broiler grid in a broiler panHi Broil To change to Lo Broil, touchUsing the clock and timer. on some models CleaningTo Set the Timer To Set the ClockTo Reset the Timer To Cancel the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowUsing the Sabbath feature. on some models How to Set for Regular Baking/RoastingCare and Cleaning Installation Instructions Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Touch the Clear/Off padAdjust the oven thermostat-Do it yourself Installation Troubleshooting InstructionsTipsTo Adjust the Thermostat on some models To Adjust the Thermostat on models with an Oven Temp KnobUsing the warming drawer. on some models When Using the Warming DrawerOn Signal Light Push and turn the control knob to any desired settingTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates Using the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning ConsumerHow to Delay the Start of Cleaning on some models To Stop a Clean Cycle on some modelsAfter a Clean Cycle on some models Care and cleaning of the range OperatingBurner Grates BurnersInstructions Installation Standard Twin Burner Assemblies on some modelsBurner Caps and Heads Tips Troubleshooting Operating InstructionsCooktop Surface Oven Air VentsTo clean the inside of the door Lift-Off Oven DoorOven Bottom Oven frame, pull them back outRemovable Kick Panel on some models Removable Storage Drawer on some modelsRemovable Warming Drawer on some models Oven Light Replacement Lower Control Panel Front Manifold Panel and KnobsOven Racks Do not remove any screws to remove the coverFoR yoUR SAFETy TooLS yoU wILL NeedMaterials yoU MAy Need Gas line shut-off valveInstallation Instructions DIMENSIoNS and Clearances For models JGB3000, JGB3001, JGB281, JGB300, JGB40028 to 281⁄4 LoCATIoN PRoVIDE ADEqUATE GAS SUPPLyCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Power cord of this appliance is equipped with a Electrical CoNNECTIoNSAn adapter may be used only on a 15-amp circuit Check oPERATIoN oF Surface Burners Seal the oPENINGSWith LP gas, some yellow tipping on outer cones is normal Adjust the Bake and BRoIL Check oPERATIoN oF oVEN BurnersOther Installing the ANTI-TIP Device WHEN ALL HooKUPS are CoMPLETEDBefore you call for service… Problem Possible Causes What To DoOven will not self-clean Oven temperature is too High to set a self-clean operationFood does not bake Oven controls improperly set Or roast properly Rack position is incorrectSelf-clean light on Oven Temp knob has not During self-clean cycleDoor appears Self-cleaning cycle has been During the self-cleaning cyclePower outage Power outage or surge Display goes blank Fuse in your home may beUnable to get Oven control pads were Display to show SF Not touched properlyAccessories Limited Time Offer! Free ShippingGE Will Replace What GE Will Not CoverFor The Period Warrantor General Electric Company. Louisville, KYMabe Will Replace What Mabe Will Not CoverWarrantor Mabe Canada Inc Burlington, Ontario Schedule Service Consumer Support