GE JGB3001, JGB3000, JGB281, JGB400 Check oPERATIoN oF Surface Burners, Seal the oPENINGS

Page 42

Installation Instructions

3ELECTRICAL CoNNECTIoNS (CoNT.)

B.Usage Situations where Appliance Power Cord will Be Disconnected Frequently.

Do not use an adapter plug in these situations because disconnecting of the power cord places undue strain on the adapter and leads to eventual failure of the adapter ground terminal. The customer should have the 2-prong wall receptacle replaced with a 3-prong (grounding) receptacle by a qualified electrician before using the appliance.

The installation of appliances designed for mobile home installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or, when such standard is not applicable, the Standard

for Manufactured Home Installations, latest edition (Manufactured Home Sites, Communities and Set-Ups), ANSI A225.1, latest edition, or with local codes. In Canada, mobile home installation must be in accordance with the current CAN/CSA Z240/MH Mobile Home Installation Code.

Electric Disconnect

nLocate disconnect plug on the range back.

nPinch sides of connector and pull out of range back.

5CHECK oPERATIoN oF SURFACE BURNERS

Operation of all cooktop and oven burners should be checked after the range and gas supply lines have been carefully checked for leaks.

Lighting the Burners

Select a top burner knob and simultaneously push in and turn to LITE position. You will hear a clicking sound indicating proper operation of the spark module. Once the air has been purged from the supply lines, burners should light within 4 seconds. After burner lights, rotate knob out of the LITE position. Try each burner in succession until all burners have been checked.

quality of Flames

The combustion quality of burner flames needs to be determined visually.

(A) Yellow flames—

Call for service

(B) Yellow tips on outer cones—

Normal for LP gas

(C) Soft blue flames—Normal for natural gas

If burner flames look like (A), call for service. Normal burner flames should look like (B) or (C), depending on the type of gas you use.

With LP gas, some yellow tipping on outer cones is normal.

4SEAL THE oPENINGS

Seal any openings in the wall behind the range and

in the floor under the range when hookups are completed.

42

6CHECK oPERATIoN oF oVEN BURNERS

A.Remove oven bottom:

nRemove the 2 screws at the rear of the oven bottom.

nGrasp the oven bottom at slots on each side.

nLift the rear enough to clear the lip of the range frame, push it back, and then pull it up and out.

Oven bottom

Page 41 Page 43
Image 42
Page 41 Page 43
Contents 49-85177 04-2010 GE Write the model and serial numbers here Model # Serial #To reduce the risk of tipping the range, the range must Be secured by a properly installed anti-tip bracket. SeeDetails before attempting to install Range within 4 inches. If it does not, the bracket must beIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS Cook MeaT aND Poultry THOROUgHLY… Operating InstructionsOperatingInstructions Care and Cleaning ELeCTRIC WaRMINg DRaWeR on some modelsCare and Cleaning Using the gas surface burnersSafety Installation Instructions Troubleshooting TipsCase of Power Failure Top-of-Range CookwareCare Installation Instructions Using the oven controlsSafety Instructions CareTouch this pad to turn the oven light on or off Safety InstructionsOr temperature by larger amounts Touch this pad to select the broil functionTroubleshooting Tips Before you begin…Oven Vent Using the upper oven Care and Cleaning Installation InstructionsSupport Hi Broil How to Set the Oven for BroilingPlace the meat or fish on a broiler grid in a broiler pan To change to Lo Broil, touchTo Set the Timer Using the clock and timer. on some modelsCleaning To Set the ClockPower Outage To Reset the TimerTo Cancel the Timer Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowCare and Cleaning Installation Instructions Using the Sabbath feature. on some modelsHow to Set for Regular Baking/Roasting Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Touch the Clear/Off padTo Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfInstallation Troubleshooting InstructionsTips To Adjust the Thermostat on models with an Oven Temp KnobOn Signal Light Using the warming drawer. on some modelsWhen Using the Warming Drawer Push and turn the control knob to any desired settingTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle ConsumerHow to Delay the Start of Cleaning on some models To Stop a Clean Cycle on some modelsAfter a Clean Cycle on some models Burner Grates Care and cleaning of the rangeOperating BurnersInstructions Installation Standard Twin Burner Assemblies on some modelsBurner Caps and Heads Cooktop Surface Tips TroubleshootingOperating Instructions Oven Air VentsOven Bottom To clean the inside of the doorLift-Off Oven Door Oven frame, pull them back outRemovable Kick Panel on some models Removable Storage Drawer on some modelsRemovable Warming Drawer on some models Oven Racks Oven Light ReplacementLower Control Panel Front Manifold Panel and Knobs Do not remove any screws to remove the coverMaterials yoU MAy Need FoR yoUR SAFETyTooLS yoU wILL Need Gas line shut-off valveInstallation Instructions DIMENSIoNS and Clearances For models JGB3000, JGB3001, JGB281, JGB300, JGB40028 to 281⁄4 LoCATIoN PRoVIDE ADEqUATE GAS SUPPLyCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Power cord of this appliance is equipped with a Electrical CoNNECTIoNSAn adapter may be used only on a 15-amp circuit Check oPERATIoN oF Surface Burners Seal the oPENINGSWith LP gas, some yellow tipping on outer cones is normal Adjust the Bake and BRoIL Check oPERATIoN oF oVEN BurnersOther Installing the ANTI-TIP Device WHEN ALL HooKUPS are CoMPLETEDBefore you call for service… Problem Possible Causes What To DoFood does not bake Oven controls improperly set Oven will not self-clean Oven temperature is tooHigh to set a self-clean operation Or roast properly Rack position is incorrectDoor appears Self-cleaning cycle has been Self-clean light on Oven Temp knob has notDuring self-clean cycle During the self-cleaning cycleUnable to get Oven control pads were Power outage Power outage or surgeDisplay goes blank Fuse in your home may be Display to show SF Not touched properlyAccessories Limited Time Offer! Free ShippingFor The Period GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYMabe Will Replace What Mabe Will Not CoverWarrantor Mabe Canada Inc Burlington, Ontario Schedule Service Consumer Support
Top Page Image Contents