GE JGB3001, JGB3000 Instructions Installation, Standard Twin Burner Assemblies on some models

Page 27

GEAppliances.com

Standard Twin Burner Assemblies (on some models)

Safety

Grate

Drip pan (if so equipped)

Surface burner

CAUTION:

Do not operate the cooktop without all burner parts, drip pans (if so equipped) and grates in place.

Clean these holes thoroughly on each burner.

For cleaning information on sealed burners, see section below. Sealed burner cooktops do not lift up.

On models with standard twin burners, the cooktop lifts up for easy access.

Turn all controls OFF before removing burner parts and drip pans (if so equipped).

The burner grates and drip pans (if so equipped) can be lifted off, making them easy to clean.

The holes in the surface burners of your range must be kept clean at all times for proper ignition and an even, unhampered flame.

You should clean the surface burners routinely, especially after bad spillovers, which could clog these holes.

Wipe off surface burners. If heavy spillover occurs, remove the surface burners from the range. Burners lift out for cleaning. Lift up the cooktop and then lift out the surface burners.

To remove burned-on food, soak the surface burner in a solution of mild liquid detergent and hot water. Soak the surface burner for 20 to 30 minutes.

For more stubborn stains, use a cleanser like Soft Scrub® brand or Bon Ami® brand. Rinse well to remove any traces of the cleanser that might clog the surface burner openings.

Do not use steel wool because it will clog the surface burner openings and scratch the surface burners. If the holes become clogged, clean them with a sewing needle or twist-tie.

Before putting the surface burner back, shake out excess water and then dry it thoroughly by setting it in a warm oven for 30 minutes. Then place it back in the range, making sure it is properly seated and level.

Check the flame pattern of each burner. If the flames are “jumpy” (not steady), clean the holes again with a sewing needle or twist-tie.

Instructions

Instructions

Operating

Care and Cleaning

Instructions

Installation

Grate

Burner cap

Burner head

Drip pan (if so equipped)

Electrode Cooktop

Sealed Burner Assemblies (on some models)

Turn all controls OFF before removing the burner parts and drip pans (if so equipped).

The burner grates, caps, burner heads and drip pans (if so equipped) can be lifted off, making them easy to clean.

CAUTION: Do not operate

the cooktop without all burner parts, drip pans (if so equipped) and grates in place.

NOTE: Do not lift the cooktop. Lifting the cooktop on sealed burner models can lead to damage and improper operation of the range.

Electrode

The electrode of the spark igniter is exposed when the burner head is removed. When one burner is turned to LITE, all the burners spark. Do not attempt to disassemble or clean around any burner while another burner is on. An electric shock may result, which could cause you to knock over hot cookware.

Troubleshooting Tips

Consumer Support

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Write the model and serial numbers here Model # Serial # 49-85177 04-2010 GERange within 4 inches. If it does not, the bracket must be Be secured by a properly installed anti-tip bracket. SeeDetails before attempting to install To reduce the risk of tipping the range, the range mustGEAppliances.com IMPORTaNT SaFeTY NOTICeAppliance as a space heater to heat or SURFaCe BURNeRS Operating Instructions Cook MeaT aND Poultry THOROUgHLY…ELeCTRIC WaRMINg DRaWeR on some models OperatingInstructions Care and CleaningInstallation Instructions Troubleshooting Tips Using the gas surface burnersSafety Care and CleaningCase of Power Failure Top-of-Range CookwareCare Care Using the oven controlsSafety Instructions Installation InstructionsTouch this pad to select the broil function Safety InstructionsOr temperature by larger amounts Touch this pad to turn the oven light on or offTroubleshooting Tips Before you begin…Oven Vent Using the upper oven Care and Cleaning Installation InstructionsSupport To change to Lo Broil, touch How to Set the Oven for BroilingPlace the meat or fish on a broiler grid in a broiler pan Hi BroilTo Set the Clock Using the clock and timer. on some modelsCleaning To Set the TimerTouch the Kitchen Timer On/Off pad twice To Reset the TimerTo Cancel the Timer Power OutageHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopIf you wish to turn OFF this feature, follow the steps below Special features of your oven control. on some modelsDesigned for use on the Jewish Sabbath and Holidays Using the Sabbath feature. on some modelsHow to Set for Regular Baking/Roasting Care and Cleaning Installation InstructionsTouch the Clear/Off pad How to Exit the Sabbath FeatureTo Adjust the Thermostat on models with an Oven Temp Knob Adjust the oven thermostat-Do it yourselfInstallation Troubleshooting InstructionsTips To Adjust the Thermostat on some modelsPush and turn the control knob to any desired setting Using the warming drawer. on some modelsWhen Using the Warming Drawer On Signal LightTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates Consumer Using the self-cleaning ovenBefore a Clean Cycle How to Set the Oven for CleaningHow to Delay the Start of Cleaning on some models To Stop a Clean Cycle on some modelsAfter a Clean Cycle on some models Burners Care and cleaning of the rangeOperating Burner GratesStandard Twin Burner Assemblies on some models Instructions InstallationBurner Caps and Heads Oven Air Vents Tips TroubleshootingOperating Instructions Cooktop SurfaceOven frame, pull them back out To clean the inside of the doorLift-Off Oven Door Oven BottomRemovable Kick Panel on some models Removable Storage Drawer on some modelsRemovable Warming Drawer on some models Do not remove any screws to remove the cover Oven Light ReplacementLower Control Panel Front Manifold Panel and Knobs Oven RacksGas line shut-off valve FoR yoUR SAFETyTooLS yoU wILL Need Materials yoU MAy NeedInstallation Instructions For models JGB3000, JGB3001, JGB281, JGB300, JGB400 DIMENSIoNS and Clearances28 to 281⁄4 LoCATIoN PRoVIDE ADEqUATE GAS SUPPLyCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Power cord of this appliance is equipped with a Electrical CoNNECTIoNSAn adapter may be used only on a 15-amp circuit Check oPERATIoN oF Surface Burners Seal the oPENINGSWith LP gas, some yellow tipping on outer cones is normal Adjust the Bake and BRoIL Check oPERATIoN oF oVEN BurnersOther WHEN ALL HooKUPS are CoMPLETED Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…Or roast properly Rack position is incorrect Oven will not self-clean Oven temperature is tooHigh to set a self-clean operation Food does not bake Oven controls improperly setDuring the self-cleaning cycle Self-clean light on Oven Temp knob has notDuring self-clean cycle Door appears Self-cleaning cycle has beenDisplay to show SF Not touched properly Power outage Power outage or surgeDisplay goes blank Fuse in your home may be Unable to get Oven control pads wereLimited Time Offer! Free Shipping AccessoriesWarrantor General Electric Company. Louisville, KY GE Will ReplaceWhat GE Will Not Cover For The PeriodMabe Will Replace What Mabe Will Not CoverWarrantor Mabe Canada Inc Burlington, Ontario Consumer Support Schedule Service
Top Page Image Contents