GE JGB400, JGB3000, JGB3001, JGB281 installation instructions Installation Instructions

Page 34

Installation Instructions

wARNING! INSTALLATIoN SAFETy INSTRUCTIoNS

Read these instructions completely and carefully.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information, consult a qualified installer, service agency, manufacturer (dealer) or the gas supplier.

Never reuse old flexible connectors. The use of old flexible connectors can cause gas leaks and personal injury. Always use NEw flexible connectors when installing

a gas appliance.

IMPoRTANT – Remove all packing material and literature from oven before connecting gas and electrical supply to range.

CAUTIoN – Do not attempt to operate the oven of this range during a power failure (Electric Ignition models only).

nHave your range installed by a qualified installer.

nYour range must be electrically grounded in accordance with local codes or, in the absence of local codes, in accordance with the National Electrical Code (ANSI/NFPA 70, latest edition). In Canada, electrical grounding must be in accordance with the current CSA C22.1 Canadian Electrical Code Part 1 and/or local codes. See electrical Connections in this section.

nBefore installing your range on linoleum or any other synthetic floor covering, make sure the floor covering can withstand 180°F without shrinking, warping or discoloring. Do not install the range over carpeting unless a sheet of 1/4″ thick plywood or similar insulator is placed between the range and carpeting.

nMake sure the wall coverings around the range can withstand heat generated by the range up to 200°F.

nAvoid placing cabinets above the range. To reduce the hazard caused by reaching over the open flames of operating burners, install a ventilation hood over the range that projects forward at least 5″ beyond the front of the cabinets.

nThe ventilating hood must be constructed of sheet metal not less than 0.0122″ thick. Install above the cooktop with a clearance of not less than 1/4″ between the hood and the underside of the combustible material or metal cabinet. The hood must be at least as wide as the appliance and centered over the appliance. Clearance between the cooking surface and the ventilation hood surface MUST NEVER BE LESS THAN 24 INCHES.

EXCEPTIoN: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform

to the installation instructions packed with that appliance.

nIf cabinets are placed above the range, allow a minimum clearance of 30″ between the cooking surface and the bottom of unprotected cabinets.

nIf a 30″ clearance between cooking surface and overhead combustible material or metal cabinets cannot be maintained, protect the underside of the cabinets above the cooktop with not less than 1/4″ insulating millboard covered with sheet metal not less than 0.0122″ thick. Clearance between the cooking surface and protected cabinets MUST NEVER BE LESS THAN

24 INCHES.

nThe vertical distance from the plane of the cooking surface to the bottom of adjacent overhead cabinets extending closer than 1″ to the plane of the range sides must not be less than 18″. (See the Dimensions and Clearances illustration in this section.)

nCAUTIoN – Items of interest to children should not be stored in cabinets above a range or on the backsplash of a range—children climbing on the range to reach items could be seriously injured.

IMPoRTANT!

Remove all tape and packaging. Make sure the burners are properly seated and level.

Lift up the cooktop (on models with standard twin burners) and remove any packing material under it.

Take the accessory pack out of the oven and/or drawer.

Check to be sure that no range parts have come loose during shipping.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents 49-85177 04-2010 GE Write the model and serial numbers here Model # Serial #To reduce the risk of tipping the range, the range must Be secured by a properly installed anti-tip bracket. SeeDetails before attempting to install Range within 4 inches. If it does not, the bracket must beIMPORTaNT SaFeTY NOTICe GEAppliances.comAppliance as a space heater to heat or SURFaCe BURNeRS Cook MeaT aND Poultry THOROUgHLY… Operating InstructionsOperatingInstructions Care and Cleaning ELeCTRIC WaRMINg DRaWeR on some modelsCare and Cleaning Using the gas surface burnersSafety Installation Instructions Troubleshooting TipsTop-of-Range Cookware Case of Power FailureCare Installation Instructions Using the oven controlsSafety Instructions CareTouch this pad to turn the oven light on or off Safety InstructionsOr temperature by larger amounts Touch this pad to select the broil functionBefore you begin… Troubleshooting TipsOven Vent Care and Cleaning Installation Instructions Using the upper ovenSupport Hi Broil How to Set the Oven for BroilingPlace the meat or fish on a broiler grid in a broiler pan To change to Lo Broil, touchTo Set the Timer Using the clock and timer. on some modelsCleaning To Set the ClockPower Outage To Reset the TimerTo Cancel the Timer Touch the Kitchen Timer On/Off pad twiceHow to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control. on some models If you wish to turn OFF this feature, follow the steps belowCare and Cleaning Installation Instructions Using the Sabbath feature. on some modelsHow to Set for Regular Baking/Roasting Designed for use on the Jewish Sabbath and HolidaysHow to Exit the Sabbath Feature Touch the Clear/Off padTo Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfInstallation Troubleshooting InstructionsTips To Adjust the Thermostat on models with an Oven Temp KnobOn Signal Light Using the warming drawer. on some modelsWhen Using the Warming Drawer Push and turn the control knob to any desired settingTo Crisp Stale Items Temperature Selection ChartTo Warm Serving Bowls and Plates How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle ConsumerTo Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Burner Grates Care and cleaning of the rangeOperating BurnersInstructions Installation Standard Twin Burner Assemblies on some modelsBurner Caps and Heads Cooktop Surface Tips TroubleshootingOperating Instructions Oven Air VentsOven Bottom To clean the inside of the doorLift-Off Oven Door Oven frame, pull them back outRemovable Storage Drawer on some models Removable Kick Panel on some modelsRemovable Warming Drawer on some models Oven Racks Oven Light ReplacementLower Control Panel Front Manifold Panel and Knobs Do not remove any screws to remove the coverMaterials yoU MAy Need FoR yoUR SAFETyTooLS yoU wILL Need Gas line shut-off valveInstallation Instructions DIMENSIoNS and Clearances For models JGB3000, JGB3001, JGB281, JGB300, JGB40028 to 281⁄4 PRoVIDE ADEqUATE GAS SUPPLy LoCATIoNCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Electrical CoNNECTIoNS Power cord of this appliance is equipped with aAn adapter may be used only on a 15-amp circuit Seal the oPENINGS Check oPERATIoN oF Surface BurnersWith LP gas, some yellow tipping on outer cones is normal Check oPERATIoN oF oVEN Burners Adjust the Bake and BRoILOther Installing the ANTI-TIP Device WHEN ALL HooKUPS are CoMPLETEDBefore you call for service… Problem Possible Causes What To DoFood does not bake Oven controls improperly set Oven will not self-clean Oven temperature is tooHigh to set a self-clean operation Or roast properly Rack position is incorrectDoor appears Self-cleaning cycle has been Self-clean light on Oven Temp knob has notDuring self-clean cycle During the self-cleaning cycleUnable to get Oven control pads were Power outage Power outage or surgeDisplay goes blank Fuse in your home may be Display to show SF Not touched properlyAccessories Limited Time Offer! Free ShippingFor The Period GE Will ReplaceWhat GE Will Not Cover Warrantor General Electric Company. Louisville, KYWhat Mabe Will Not Cover Mabe Will ReplaceWarrantor Mabe Canada Inc Burlington, Ontario Schedule Service Consumer Support
Top Page Image Contents