GE JGB281 FoR yoUR SAFETy, TooLS yoU wILL Need, Materials yoU MAy Need, Gas line shut-off valve

Page 33

Installation Instructions

Range

If you have questions, call 1.800.GE.CARES or visit our Website at: GEAppliances.com

In the Commonwealth of Massachusetts:

This product must be installed by a licensed plumber or gas fitter.

When using ball-type gas shut-off valves, they shall be the T-handle type.

A flexible gas connector, when used, must not exceed 3 feet.

BEFoRE yoU BEGIN

Read these instructions completely and carefully.

Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/CGA- B149.1 or the current Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range has been design-certified

by CSA International according to ANSI Z21.1, latest edition, and Canadian Gas Association according to CAN/CGA-1.1 latest edition.

As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find these precautions in the Important Safety Information section in the front of this manual. Read them carefully.

IMPoRTANT – Save these instructions for local electrical inspector’s use.

IMPoRTANT – Observe all governing codes and ordinances.

Note to Installer – Be sure to leave these instructions with the Consumer.

Note to Consumer – Keep these instructions for future reference.

Note – This appliance must be properly grounded.

Servicer – The electrical diagram is in an envelope attached to the back of the range.

Skill level – Installation of this appliance requires basic mechanical skills.

Proper installation is the responsibility of the installer.

Product failure due to improper installation is not covered under the Warranty.

PART INCLUDED

Anti-Tip bracket kit

FoR yoUR SAFETy

Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

If you smell gas:

Open windows.

Don’t touch electrical switches.

Extinguish any open flame.

Immediately call your gas supplier.

TooLS yoU wILL NEED

Phillips screwdriver

 

Flat-blade screwdriver

Open-end or

adjustable wrench

 

Pencil and ruler

 

 

Level

Pipe wrenches (2)

 

(one for backup)

Drill, awl or nail

 

MATERIALS yoU MAy NEED

Gas line shut-off valve.

Pipe-joint sealant or UL-approved pipe thread tape with Teflon* that resists action of natural and LP gases.

Flexible metal appliance connector (1/2I.D.)

A 5-foot length is recommended for ease of installation but other lengths are acceptable. Never use an old connector when installing a new range.

Flare union adapter for connection to gas supply line (3/4or 1/2NPT x 1/2I.D.)

Flare union adapter for connection to pressure regulator on range (1/2NPT x 1/2I.D.)

Liquid leak detector or soapy water.

Lag bolt or 1/2O.D. sleeve anchor (for concrete floors only).

*Teflon: Registered trademark of DuPont

33

Image 33
Contents Write the model and serial numbers here Model # Serial # 49-85177 04-2010 GEDetails before attempting to install Be secured by a properly installed anti-tip bracket. SeeTo reduce the risk of tipping the range, the range must Range within 4 inches. If it does not, the bracket must beGEAppliances.com IMPORTaNT SaFeTY NOTICeAppliance as a space heater to heat or SURFaCe BURNeRS Operating Instructions Cook MeaT aND Poultry THOROUgHLY…ELeCTRIC WaRMINg DRaWeR on some models OperatingInstructions Care and CleaningSafety Using the gas surface burnersCare and Cleaning Installation Instructions Troubleshooting TipsCase of Power Failure Top-of-Range CookwareCare Safety Instructions Using the oven controlsInstallation Instructions CareOr temperature by larger amounts Safety InstructionsTouch this pad to turn the oven light on or off Touch this pad to select the broil functionTroubleshooting Tips Before you begin…Oven Vent Using the upper oven Care and Cleaning Installation InstructionsSupport Place the meat or fish on a broiler grid in a broiler pan How to Set the Oven for BroilingHi Broil To change to Lo Broil, touchCleaning Using the clock and timer. on some modelsTo Set the Timer To Set the ClockTo Cancel the Timer To Reset the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopIf you wish to turn OFF this feature, follow the steps below Special features of your oven control. on some modelsHow to Set for Regular Baking/Roasting Using the Sabbath feature. on some modelsCare and Cleaning Installation Instructions Designed for use on the Jewish Sabbath and HolidaysTouch the Clear/Off pad How to Exit the Sabbath FeatureInstallation Troubleshooting InstructionsTips Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat on some models To Adjust the Thermostat on models with an Oven Temp KnobWhen Using the Warming Drawer Using the warming drawer. on some modelsOn Signal Light Push and turn the control knob to any desired settingTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates Before a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning ConsumerHow to Delay the Start of Cleaning on some models To Stop a Clean Cycle on some modelsAfter a Clean Cycle on some models Operating Care and cleaning of the rangeBurner Grates BurnersStandard Twin Burner Assemblies on some models Instructions InstallationBurner Caps and Heads Operating Instructions Tips TroubleshootingCooktop Surface Oven Air VentsLift-Off Oven Door To clean the inside of the doorOven Bottom Oven frame, pull them back outRemovable Kick Panel on some models Removable Storage Drawer on some modelsRemovable Warming Drawer on some models Lower Control Panel Front Manifold Panel and Knobs Oven Light ReplacementOven Racks Do not remove any screws to remove the coverTooLS yoU wILL Need FoR yoUR SAFETyMaterials yoU MAy Need Gas line shut-off valveInstallation Instructions For models JGB3000, JGB3001, JGB281, JGB300, JGB400 DIMENSIoNS and Clearances28 to 281⁄4 LoCATIoN PRoVIDE ADEqUATE GAS SUPPLyCoNNECT the Range To GAS Range hookup Alternate Hookup Pressure regulator Manifold pipe Power cord of this appliance is equipped with a Electrical CoNNECTIoNSAn adapter may be used only on a 15-amp circuit Check oPERATIoN oF Surface Burners Seal the oPENINGSWith LP gas, some yellow tipping on outer cones is normal Adjust the Bake and BRoIL Check oPERATIoN oF oVEN BurnersOther WHEN ALL HooKUPS are CoMPLETED Installing the ANTI-TIP DeviceProblem Possible Causes What To Do Before you call for service…High to set a self-clean operation Oven will not self-clean Oven temperature is tooFood does not bake Oven controls improperly set Or roast properly Rack position is incorrectDuring self-clean cycle Self-clean light on Oven Temp knob has notDoor appears Self-cleaning cycle has been During the self-cleaning cycleDisplay goes blank Fuse in your home may be Power outage Power outage or surgeUnable to get Oven control pads were Display to show SF Not touched properlyLimited Time Offer! Free Shipping AccessoriesWhat GE Will Not Cover GE Will ReplaceFor The Period Warrantor General Electric Company. Louisville, KYMabe Will Replace What Mabe Will Not CoverWarrantor Mabe Canada Inc Burlington, Ontario Consumer Support Schedule Service