Maytag 700 manual Surface Cooking, Surface Controls, Pilotless Ignition, Surface Control Knobs

Page 6

Surface Cooking

LO: Use to simmer foods, keep foods warm and melt chocolate or butter. Some cooking may take place on the LO setting if the pan is covered. It is possible to reduce the heat by rotating the knob toward OFF. Be sure flame is stable.

HI: Use to bring liquid to a boil, or reach pressure in a pressure cooker. Always reduce setting to a lower heat when liquids begin to boil or foods begin to cook.

An intermediate flame size is used to continue cooking. Food will not cook any faster when a higher flame setting is used than needed to maintain a gentle boil. Water boils at the same temperature whether boiling gently or vigorously.

Surface Controls

CAUTION

•If flame should go out during a cooking operation, turn the burner off. If a strong gas odor is detected, open a window and wait five minutes before relighting the burner.

•Be sure all surface controls are set in the OFF position before supplying gas to the range.

•NEVER touch cooktop until it has cooled. Expect some parts of the cooktop, especially around the burners, to become warm or hot during cooking. Use potholders to protect hands.

Pilotless Ignition

Pilotless ignition eliminates the need for a constant standing pilot light. Each surface burner has a spark ignitor. Use care when cleaning around the surface burner.

If the surface burner does not light, check if ignitor is broken, soiled or wet.

Surface Control Knobs

Use to turn on the surface burners. An infinite choice of heat settings is available from LO to HI. At the HI setting a detent or notch may be felt. The knobs can be set on or between any of the settings.

Graphics next to the knob identify which burner the knob controls. For example, the graphic at right shows the left front burner location.

Setting the controls:

The size and type of cookware will affect the heat setting.

1.Place a pan on the burner grate.

•The burner flame may lift off or appear separated from the port if a pan is not placed on the grate.

2.Push in and turn the knob counterclockwise to the LITE setting.

•A clicking (spark) sound will be heard and the burner will light. (All five ignitors will spark when any surface burner knob is turned to the LITE position.)

3.After the burner lights, turn knob to desired flame size.

•The ignitor will continue to spark until the knob is turned past the LITE position.

5

Image 6

Contents Table of Contents Use & Care GuideGas Precision Touch Control Recognize Safety Symbols, Words, Labels InstructionsGeneral Instructions To Prevent Fire or Smoke Damage Important Safety Instructions Child Safety Case of FireCooking Safety Utensil SafetyImportant Safety Notice and Warning Cleaning SafetySelf-Clean Oven Save These Instructions for Future ReferenceSurface Controls Setting the controlsSurface Cooking Pilotless IgnitionCooktop Operating During a Power FailurePower Boost Burner Sealed Gas BurnersSurface Cooking Burner GratesControl Panel Using the TouchpadsOven Cooking ClockTimer Fault CodesLocking the Control Oven Door Baking Notes BakingCook & Hold Baking Differences Between Your Old and New OvenDelay Cook & Hold Keep Warm Notes To cancel Keep WarmKeep Warm To set Keep WarmBroil Notes Broiling ChartBroiling Rack Total Food PositionTo cancel Bake when in Sabbath Mode Automatic Shut-Off Sabbath ModeSabbath Mode Notes To cancel the Sabbath ModeTo cancel a Favorite cycle in progress Adjusting the Oven TemperatureTo adjust the oven temperature FavoriteOven Light Oven VentOven Racks Oven BottomCreate-A-SpaceTMHalf Rack Baking Layer Cakes on Two RacksTwo rack Use rack positions 3 and 6, or 2 Before Self-Cleaning To set Self-CleanTo Delay a Self-Clean Cycle During the Self-Clean Cycle After Self-CleaningCare & Cleaning Cleaning ProceduresPart Procedure Glass To restore ease of movement, then wipe off excess oilFirst Stainless SteelLeveling Legs MaintenanceOven Window Electrical ConnectionRemoval of Gas Appliance Storage DrawerBrowning TroubleshootingProblem Solution Inches between pans and oven wallWord is not displayed Control and door may be locked. SeeOff. This is normal Page What is Not Covered By These Warranties Warranty & ServiceWarranty If You Need ServiceCuisinière à gaz à touches de précision Table des matièresInstructions de sécurité importantes Les instructions de sécurité importantes et les paragraphesEn cas d’incendie Instructions généralesPour éviter un incendie ou des dommages par la fumée Sécurité pour les enfantsFamiliarisation avec l’appareil Cuisson et sécuritéUstensiles et sécurité Nettoyage et sécuritéFour autonettoyant Avertissement et avis important pour la sécurité Conserver ces instructions pour consultation ultérieureCuisson sur la surface Brûleurs à gaz scellés Brûleur de haute performance Power BoostSurface de cuisson Brûleur de mijotageHorloge Tableau de commandeCuisson dans le four Utilisation des touchesVerrouillage des commandes et de la porte du four MinuterieCodes d’anomalie Différences de cuisson entre l’ancien four et le nouveau Cuisson couranteCuisson et maintien Remarques sur la cuisson courante au fourCuisson et maintien différée Programmation du maintien au chaud Maintien au chaudRemarques sur la fonction maintien au chaud Annulation du maintien au chaudTableau de cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Position DES Degré DE Temps DE AlimentsAnnulation du mode sabbat Arrêt automatique Mode sabbatRemarques sur le mode sabbat Changement de la température F/CAjustement de la température du four Ajustement de la température du fourFavori Démarrage d’un cycle programmé dans favoriÉclairage du four Allumage sans flamme de veilleÉvent du four Sole du fourDeux grilles Utiliser les positions 3 et 6, ou 2 et Demi-grille Create-A-SpaceMCCuisson de gâteaux à étages sur deux grilles Toujours libre pour loger une cocotteProgrammation de l’autonettoyage NettoyageAvant l’autonettoyage Démarrage différé d’un cycle d’autonettoyagePendant le cycle d’autonettoyage Après le cycle d’autonettoyageMéthodes de nettoyage Pièce NettoyageDe remisage PanneauxLatéraux, tiroir Et poignéesEntretien Déplacement d’un appareil à gaz Tiroir de remisageDépose Problème Solution Recherche des pannesParticulièrement les résidus d’aliments acides ou sucrés Les commandes et la porte sont peut-être verrouillées. VoirImpossibilité d’autonettoyage La porte du four ne se déverrouilleRemarques Ne sont pas couverts par ces garanties Garantie et service après-venteGarantie Si vous avez besoin d’aideEstufa a Gas con Control a Precisión Sensible al Tacto Tabla de MateriasInstrucciones SeguridadCanadá En Caso de Incendio Instrucciones GeneralesPara Evitar un Incendio o Daño Causado por el Humo Seguridad para los NiñosGeneralidades Seguridad Para CocinarUtensilios Apropiados Seguridad de la LimpiezaHorno Autolimpiante Aviso y Advertencia Importante Sobre Seguridad Conserve estas Instrucciones para Referencia FuturaEncendido Sin Piloto Cocinando en la EstufaControles Superiores Perillas de Control de los Elementos SuperioresQuemadores à Gaz Sellados Quemador de Alto Rendimiento Power BoostCubierta Quemador para Cocinar a Fuego Lento‘Clock’ Reloj Cocinando en el HornoPanel de Control Uso de las TeclasCódigos de Errores ‘Timer’ TemporizadorBloqueo de los Controles y de la Puerta del Horno Mantener Caliente ‘Cook & Hold’ Cocción y‘Bake’ Horneado Notas sobre Horneado‘Delay Cook & Hold’ Cocción y Mantener Caliente DiferidoNotas sobre ‘Keep Warm’ Para cancelar ‘Keep Warm’‘Keep Warm’ Mantener Caliente Para programar ‘Keep Warm’Tabla de Asar a la Parrilla ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Para programar ‘Broil’Cierre Automático Modo Sabático Cambio de la temperatura de F/CNotas Sobre el Modo Sabático Ajuste de la temperatura del horno ‘Favorite’ FavoritoParrillas del Horno Respiradero del HornoPanel Inferior del Horno Posiciones de la ParrillaMedia Parrilla Create-A-SpaceMR Horneado de Pasteles de Capas en Dos ParrillasDos parrillas Use la posición 3 y 6 o 2 y Para diferir un ciclo de autolimpieza Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Limpie el marco del horno, el marco deDespués del ciclo de autolimpieza Durante el ciclo de autolimpiezaProcedimientos de Limpieza Pieza Procedimiento DE LimpiezaCuidado y Limpieza Mantenimiento Para sacar Retiro de la Estufa a GasGaveta de Almacenamiento Para volver a colocarProblema Solución Localización y Solución de AveríasVerifique si la puerta está cerrada El horno no se autolimpiaPáginas Verifique si el control está en Modo Sabático. Ver págNotas Lo que no cubren estas garantías Garantía y ServicioGarantía Si necesita servicio