U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
MOUNTING OVEN TO THE WALL
Two people are recommended to attach the Microwave Oven/Hood to the Mounting Plate.
1.Thread the Power Supply Cord through the hole made in the bottom of the top cabinet. Install the oven by snapping it onto the Mounting Plate. See Figure 23.
2.Use two Tapping Screws 5 to secure the levers that are on the bottom of the oven. See Figure 24.
3.Use two Top Cabinet Screws 3 and two Flat Washers 6, supplied in the INSTALLATION HARDWARE, to attach the unit to the top cabinet. See Figure 25.
4.Make a bundle of the Power Supply Cord and attach it to the inside of the cabinet using the Power Cord Hanger 4. See Figure 25.
5.Attach the bottom sash #to the oven by sliding the two tabs into the rectangular openings located on the bottom front of the oven. See figure 26 (A).
6.Use 5 Tapping Screws 4 x 12mm 5 from the INSTALLATION HARDWARE and tighten into place. See Figure 26 (B).
Figure 23 | Figure 24 | Figure 25 |
5
CHECKLIST FOR INSTALLATION
1.Make sure the unit has been installed according to all of the Installation Instructions and the Wall and Top Cabinet Templates.
2.Plug in the power cord.
3.Keep the Operation Manual.
3 | 4 |
|
6
5
Figure 26
(A)
(A)
(B) (B)
(B)
(B) (B)
O P T I O N A L A C C E S S O R I E S
Two optional accessories are available for this oven.
1.Charcoal Filter
2.Filler Panel Kit. For use when the oven is installed in a
To purchase contact: | Imperial Cal Products, Inc. |
|
| 1141 S. Acacia Ave. |
|
| Fullerton, CA 92831 |
|
| Phone: (714) | Fax: (714) |
14