American Panel BCIP Installation, Color Code Chart, Plug/Connector Destination, Cable/Wire

Page 11

COLOR CODE CHART

INSTALLATION

DRAWING #6

NOTE: Route the micro-switch (B) wires through the wall and bring them inside the box at approx. 6” above the door. Insulate the wall hole (s) with silicone or grommets. Take precaution to protect the heater wires inside the door frame.

COLOR CODE CHART

	PLUG/CONNECTOR	PLUG/CONNECTOR DESTINATION	CABLE/WIRE
	COLOR	PLUG/CONNECTOR DESTINATION	TYPE
	COLOR		TYPE
	QUICK-CONNECT (PLUG-CONNECTOR) CABLES
	BLUE	FANS	SOOW
	YELLOW	DEFROST HEATERS	SOOW
	GRAY	SOLENOID VALVE	SOOW
	WHITE	INTERIOR LIGHT	SOOW
	GREEN	UV LIGHT	SOOW
	BROWN	DOOR SWITCH	SOOW / WIRE
	ORANGE	DOOR / WINDOW HEATERS	SOOW / CONN. BOX
	RTD (FOOD, AIR & DEFROST) PROBES (GREY WIRE)
	GREEN	PRODUCT PROBE	THERMOCOUPLE (OPTIONAL)
	BLUE	PRODUCT PROBE	THERMOCOUPLE (OPTIONAL)
	YELLOW	PRODUCT PROBE	THERMOCOUPLE (OPTIONAL)
	RED	PRODUCT PROBE	THERMOCOUPLE (STANDARD)
	BROWN	AIR PROBE	THERMOCOUPLE (STANDARD)
	WHITE	DEFROST PROBE	THERMOCOUPLE (STANDARD)

9

Image 11

Contents REV. C E-mail service@americanpanel.comAmerican Panel Corporation 5800 S.E. 78th Street, Ocala, Florida Phone 352 245-7055 Fax 352“Our reputation rests on the steadfast pursuit of your satisfaction” 5800 S.E. 78 th Street, Ocala, Florida Phone 352 245-7055 Fax 352Index INDEXA. Introduction INTRODUCTIONCONTROLLER B. Installation INSTALLATIONB.2. Single Unit Installation AP40BC250-12 And BCCP-1 INSTALLATION PHOTO #2 DRAWING # PHOTO #3 B.2.3. Electrical Connections CABLE/WIRE COLOR CODE CHARTPLUG/CONNECTOR PLUG/CONNECTOR DESTINATIONPHOTO #4 PHOTO #5 PHOTO #6 PHOTO #8 PHOTO #7 Door magnetic switch on the left Magnet on the rightii AIR COOLED C. Refrigeration Unit Installationi CABINET electrical power supplies FIG # CONDENSATE DRAINAGE CONNECTION VERIFYING CORRECT INSTALLATIONAutomatic Mode PROGRAMMINGD. Programming The Controller WARNINGS PREPARATIOND.3. Programming Modes a three button combination using , , , , . For example, press PROGRAMMING PROGRAMMING PROGRAMMING PROGRAMMING D.5.4. Parameter Programming For UV Cycle The Parameter Programming is now complete E. Printer Optional PROGRAMMING Loading OPERATINGF. Operating And Maintaining The Unit Panningair temperature screen The food temperature screenair temperature screen the food temperature screenOPERATING F.2.6. Error Messages And Troubleshooting Warnings MAINTENANCEDaily Cleaning Preventive Maintenance As neededcontractor. It is not covered by this Warranty WARRANTYMANUAL APPENDIXESAppendixes AUTOAppendix 2 Electrical Schematic Appendix 3 Electrical Schematic Number PartDescription Appendix 5 Ordering Printer Supplies Ribbon & Paper ƒ Click on Sales & Service ƒ Click on Dealer Locator5800 S.E. 78th Street, Ocala, Florida Phone 352 245-7055 Fax 352 E-mail service@americanpanel.comAmerican Panel Corporation