D.3. Programming Modes

PROGRAMMING

All American Panel Corporation blast chillers are initially programmed at the factory. These settings may be considered standard for AP40BC250-12, AP40BC250-2-12, BCCP-1, BCCP-2, and BCIP units. However, the customer may change any of these settings as indicated by necessity.

There are two programming modes to be covered:

Initial Programming - settings like year, month, date, time, and several other parameters. Parameter Programming - settings that control the chilling cycles.

To program the controller the customer can either use the control panel at the unit, or the PC application. The front panel buttons are divided into 3 groups, as follows:

1.		3.
	On/Off		Select
	Start/Stop		Up



2.
	Automatic Cycle		Down
	Automatic Cycle
	Manual Cycle		Enter


	Defrost Cycle


	UV Cycle


	Print

D.4. Initial Programming

The initial configuration of the system can be performed in Initial Programming mode. This includes setting the current year, month, date and time, as well as several other parameters.

Note: During the programming steps, any delay longer than 20 seconds before pushing the next button will cause the

controller to revert to “OFF” state and the display will show: OFF. TO AVOID THIS, THE FOLLOWING INSTRUCTIONS SHOULD BE CAREFULLY REVIEWED AND THE DESIRED SETTINGS SHOULD BE DETERMINED BEFORE PROCEEDING.

If the control panel goes to OFF state, programming mode will have to be restarted.

Note: During programming, pressing and holding or button for more than two seconds will increase the value changing speed.

D.4.1. Initial Programming Procedure And Parameters

The instructions below contain screens with the exact messages displayed by the controller during programming procedure. Follow the notes located to the right of these screens.

Check that the unit is plugged in and power is available. The controller should be in OFF state. If it is not, press .

Press and hold for approximately 5 seconds. When the command is accepted, the controller will give one long beep

and ask the operator to select the desired language. Use and buttons to scroll thru the language settings.

Press when done.