PROGRAMMING
Use 
and 
buttons to increase or decrease the low air temperature (cut out) setting for the second part of the cycle.
Press 
when done.
Note: The second part of the cycle is the holding mode.
Use 
and 
buttons to increase or decrease the high air temperature (cut in) setting for the second part of the cycle.
Press 
when done.
Use 
and 
buttons to increase or decrease the amount of time the controller is going to keep the unit in the first part of the manual cycle. After the time expires the unit is going to enter the holding mode.
Press 
when done. The controller will move to CHOOSE OPERATING CYCLE
screen. Press 
to exit the programming mode, or choose another cycle to program.
D.5.3. Parameter Programming For Defrost Cycle
The controller will ask the operator to choose an operating cycle. Press 
to set the parameters for the defrost cycle.
Use 
and 
buttons to choose between electric and air flow defrost. Choose electric defrost only if your unit is equipped with electric heaters. Otherwise choose “Air Flow” defrost.
If the defrost cycle type is set to electric, the controller will display:
Use 
and 
buttons to increase or decrease the evaporator temperature at which the controller will finish the defrost cycle.
Press 
when done.
If the defrost cycle type is set to “Air Flow” the controller will display:
Use 
and 
buttons to increase or decrease the length of the defrost cycle.
23