American Panel AP40BC250-2-12, BCCP-1, BCIP, BCCP-2, AP40BC250-12 manual Installation, PHOTO #6

Page 13

PHOTO #6

INSTALLATION

PHOTO #6

B.3. Double Unit Installation AP40BC250-2-12, BCCP-2, And BCIP

Installation procedures are similar with the ones for the single unit. Each of the two evaporators is fed by one condensing unit.

Both single units installed in a double box are controlled by one electronic controller. The difference is made by the double number of power cables and air probe cables. The two frames to be installed by the control board are marked

#1. The other two frames to be installed on the back are marked # 2 (see PHOTO #8 page 12 and PHOTO #9, page 13). If the markings are lost or missing and you need to select the frames to be installed close to the controller, look for the ones with extra long cables. If the frames are installed improperly, the feeding cables will be short. Drill holes through the partition walls above the top of the frames. Run the cables with connectors through, and plug them according to the color codes. Protect the cables from the rough edges of the drilled holes into the partition walls.

11

Image 13

Contents American Panel Corporation E-mail service@americanpanel.com5800 S.E. 78th Street, Ocala, Florida Phone 352 245-7055 Fax 352 REV. C“Our reputation rests on the steadfast pursuit of your satisfaction” 5800 S.E. 78 th Street, Ocala, Florida Phone 352 245-7055 Fax 352Index INDEXA. Introduction INTRODUCTIONCONTROLLER B. Installation INSTALLATIONB.2. Single Unit Installation AP40BC250-12 And BCCP-1 INSTALLATION PHOTO #2 DRAWING # PHOTO #3 B.2.3. Electrical Connections PLUG/CONNECTOR COLOR CODE CHARTPLUG/CONNECTOR DESTINATION CABLE/WIREPHOTO #4 PHOTO #5 PHOTO #6 PHOTO #8 PHOTO #7 Door magnetic switch on the left Magnet on the righti CABINET C. Refrigeration Unit Installationii AIR COOLED electrical power supplies FIG # CONDENSATE DRAINAGE CONNECTION VERIFYING CORRECT INSTALLATIOND. Programming The Controller WARNINGS PROGRAMMINGPREPARATION Automatic ModeD.3. Programming Modes a three button combination using , , , , . For example, press PROGRAMMING PROGRAMMING PROGRAMMING PROGRAMMING D.5.4. Parameter Programming For UV Cycle The Parameter Programming is now complete E. Printer Optional PROGRAMMING F. Operating And Maintaining The Unit OPERATINGPanning Loadingair temperature screen The food temperature screenair temperature screen the food temperature screenOPERATING F.2.6. Error Messages And Troubleshooting Daily Cleaning MAINTENANCEPreventive Maintenance As needed Warningscontractor. It is not covered by this Warranty WARRANTYAppendixes APPENDIXESAUTO MANUALAppendix 2 Electrical Schematic Appendix 3 Electrical Schematic Description PartNumber Appendix 5 Ordering Printer Supplies Ribbon & Paper ƒ Click on Sales & Service ƒ Click on Dealer LocatorAmerican Panel Corporation E-mail service@americanpanel.com5800 S.E. 78th Street, Ocala, Florida Phone 352 245-7055 Fax 352