Roland MMP-2 Meters, Edit Channel Select Edit CH Select, Input, Dynamics CMP / EXP, Output OUT

Set Up and Basic Operations

4.Re-press [ENTER]. Reset will be executed. Once the reset is completed, system

go back to normal screen after indicating “Completed.” on screen.

Effect		Parameter	Value	Effect		Parameter	Value
mic modeling		MODEL	OFF	compressor		COMP	OFF
		INPUT	C3000B			TYPE	SOLID
		OUTPUT	SML.D			KEYIN	same channel
		PROXFX	0			THRESH	-24.0
		TIME	0			RATIO	2.00:1
equalizer		EQ	ON			KNEE	HARD
		ATT	0			ATTACK	10.0
		LOTYPE	PEAK			RELEAS	500
	LOW	LOW	80			LEVEL	0.0
		GAIN	0.0			A.GAIN	OFF
		Q	2.00	expander		EXP	OFF
		LMTYPE	PEAK			KEYIN	same channel
	LO-MID	LO-MID	400			THRESH	-40
		GAIN	0.0			RATIO	2.00:1
		Q	2.00			ATTACK	0.0
		HMTYPE	PEAK			RELEAS	500
	HI-MID	HI-MID	2.00k	enhancer/de-esser		ENH/DE	OFF
		GAIN	0.0			TYPE	ENH
		Q	2.00			SENS	25
		HITYPE	PEAK		ENH	FREQ	10.0k
	HIGH	HIGH	10.0k			ENHLEV	6,0
		GAIN	0.0			SENS	25
		Q	2.00		DES	FREQ	10.0k
						DESREJ	-6.0

■Meters

Press the [METER] button to select from the three types of level meters.

Input (IN)

This displays the input level. The [METER] button lights up in green.

Dynamics (CMP / EXP)

This displays the level suppressed by the dynamics processors (gain reduction).

The [METER] button lights up in red.

Pressing the [PAGE] buttons switches what is displayed between the compressor and the expander.

Output (OUT)

This displays the output level. The [METER] button lights up in orange.

■Edit Channel Select (EDIT CH SELECT)

These choose the channel to edit. Pressing an [EDIT CH SELECT] button makes the button light up green, showing that the corresponding channel is selected. You make the settings for effects one channel at a time. The system enters Link Mode pressing channel 2 button holding down channel 1 button. (“Linking” (p. 28))

16