Roland owner manual Macintosh / FreeMIDI, Installing the MMP-2 Driver

Use of computer and setup

8.Verify that the MMP-2 is listed in the OMS MIDI device setting dialog box, then click [OK].

9.A dialog box will appear, allowing you to save the settings file.

Input the desired filename, and click [Save].

10.A settings window like the one shown at right will appear.

Click on the name, and change the name to “Roland MMP-2 Interface”

*If the name is same, it may be possible for some MIDI application to confuse the name of interface or connected equipment.

*In case of using “MMP-2 Editor”, please remark that the name of the device (“Roland MMP-2” comes with keyboard icon in the setting window shown at right) should always be start from “Roland MMP-2”, otherwise MMP-2 Editor can not detect MMP-2 automatically.

*This is only one possible example of the settings window. The settings window that you actually see will differ depending on your system.

11.Select the [Quit] command from the File menu to exit OMS Setup. If the Save dialog box appears, input a filename, and click [Save].

This completes driver settings.

Read “ReadMe” of adopted CD-ROM in case you use MMP-2 Editor.

Macintosh / FreeMIDI

Installing the MMP-2 Driver

Use the following procedure to install the MMP-2 driver.

*Disconnect the MMP-2 from your computer before starting up Macintosh.

*Exit all applications before you begin installing the driver.

*The MMP-2 FreeMIDI Driver included on the disc is provided as an additional module that allows the MMP-2 to be used with FreeMIDI. In order to use it, FreeMIDI must already be installed on the start-up hard disk.

1.In the “MMP-2 Driver E” folder of the CD-ROM, double-click the “MMP-2 FreeMIDI Driver-E Installer” icon to start up the installer.

38