Kenmore 790.3104, 790.3103 manual Setting Oven Controls, Instructions, Press, Display

Setting Oven Controls

Setting the Clock

The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day

operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash (See Fig. 1).

				INSTRUCTIONS			PRESS
To set the clock (example below for 1:30)
1.	Press	(_.	"CLO"		will appear in the display (Figure	2).	O
2.	Press	(_	(_	(_	pads to set the time of day to 1:30		QQdb
	(Figure	3). "CLO"		will stay in the display. Press		"CLO"

will disappear and the clock will start (Figure 4).

Figure 1

DISPLAY

Figure 2

Changing between 12 or 24 hour time of day display

1.Press and hold _'_ for 7 seconds. "CLO" will appear in the display. "12h" (Figure 5) or "24h" (Figure 6) appears in the display and the control beeps once.

2. Press _ to switch between the 12 and 24 hour time of clay

display. The display will show either "12h" (Figure 5) or "24h" (Figure 6).

3. Press to accept the change or press _ to reject the

change.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was

chosen, the clock will now display time from 0:00 through 23:59 hours.

0

for 7 seconds

Q

O

Figure 3

!!C

Figure 4

Figure 5

Figure 6

17