Your dispenser can be turned off for easy cleaning or to prevent unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the product, to the ice maker, or to the dispenser light. It simply deactivates the dispenser levers.
To turn off the dispenser, press and hold the lock button until the red indicator appears below LOCKED. The ice and water dispensers will not work. To unlock the dispenser, press the lock button until the indicator disappears. Then continue to dispense ice or water as usual.
The water filter status display will help you know when it is time to change your water filter. A new filter should display a reading of 99%. The number on the display decreases as the filter life is used. It is recommended that you replace the filter when the status displays 0% OR when water flow to your water dispenser or ice maker decreases noticeably. To change the filter, see "Changing the Water Filter" later in this section.
INDICATOR:STATUS:
99 | percent | New | filter installed |
10 | percent | Order | replacement filter |
0 percent OR flow decreases | Replace filter | ||
After changing the filter, reset the status display by pressing and holding RESET for 2 seconds. The status display will change to 99% when it is reset.
WATER FILTER
PERCENT REMAINING
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Changing the Water Filter
The water filter is located in the base grille below the freezer compartment door. It is not necessary to remove the base grille to remove the filter.
1.Remove the filter by pressing the eject button and pulling straight out on the cap.
•Avoid twisting the cap when removing the filter because this could cause the cap to come off. If this occurs, replace the cap and pull the filter straight out.
•There will be water in the filter. Some spilling may occur.
A. Eject button
B.Cap
2.Remove the cap by turning it counterclockwise until it stops.
IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.
3.Take the new filter out of its packaging and remove the protective cover from
A. Protective cover
B.O-rings
4.Place the cap (removed in Step 2) on the new filter. Align the ridge on the cap with the arrow in the filter. Turn the cap clockwise until it snaps into place.
A. Eject button
B. Groove on filter
C. Ridge on cap
5.Push the new filter into the opening in the base grille. As the filter is inserted, the eject button will depress. The eject button will pop back out when the filter is fully engaged.
12