Teledyne 2230R instruction manual Specifications, Dimensions Weight

Page 7

MODEL 2230R, Process Hydrogen Analyzer

2. SPECIFICATIONS

Process Gas Stream

Ambient Temperature

Power Supply

Environmental

Ingress Protection

Analog Outputs

Serial Communications Relay Contacts (Optional)

Dimensions

Weight

Product Life Expectancy Certifications

Temperature: -20°C to 100°C

Flow Rate: 0 to 50 slpm

Operating: -20°C to 40°C

Storage: -40°C to 50°C

8 VDC to 13 VDC, 1.0 A Indoor/Outdoor Use Altit ude up to 2000 meters Pollution degree 2 environment IP64 capable

Output Voltages OR

0 VDC to 5 VDC

1 VDC to 5 VDC

Output Currents

4 mA to 20 mA

0 mA to 20 mA

User-specific ranges available

RS-232 or RS-422

(Two programmable 60 VDC / 1 A SPDT relays with both normally open N.O.) and normally closed (N.C.) contacts. See following figure (dimensions in inches [mm] )

0.37kg (0.82 lb.) 10 yeears

Page 7

Image 7
Contents 30/2011 ECO # Important NoticesCopyright 2006 Teledyne Analytical Instruments Model 2230R, Process Hydrogen Analyzer Safety Messages Table of Contents Teledyne Instruments DescriptionTeledyne Analytical Instruments Process Hydrogen Analyzer Model 2230RDimensions Weight SpecificationsModel 2230R, Process Hydrogen Analyzer Operation Unit Location Process Connection Hydrogen Detected above R2 set point/ Unit fault detected Status Indicator ColorNormal operation / Hydrogen Detected below R1 set point Description Power/Analog Output ConnectorWire Color Electrical & Communication ConnectionsAnalog Output Voltage Analog Output Range Power-On Self Diagnostic ErrorExample Display₂ Messages 0.0000 0.0000 Example ESC Format fmt Fmt opt Low high Low high err not rdy AtmFormat Bit Value Identifiers Bit value Hexadecimal Calculation Errors Heater StateOptions opt Options Bit Value IdentifiersTwo place hexadecimal value Fmt Two Place Hexadecimal Value Command prompt G fmt opt = g 8bOpt Two Place Hexadecimal Value Field Maintenance CleaningGas Connection Verification Interval Tolerance Chart Gas Temperature 65cVerification Accuracy Drift/weekVerification Procedure An average will be calculated StepVerification complete If the unit fails Verification, you will see the followingCalibration Calibration ProcedureCalibration Interval Field Calibration Steps Model 2230R, Process Hydrogen Analyzer