Woods Equipment S105-3, S106-3, S105Q-3, S106Q-3 Chain Shielding Repair, Cleaning, After Each Use

1.	Clutch	9. Compression spring
2.	Yoke & square shaft	10.	Flange lock nut
3.	Clutch back-up plate	11. Bolt
4.	Clutch back-up plate	12.	Lock nut
5.	Friction disc	13.	Sleeve
6.	Yoke & plate asy	14.	Bolt
7.	Bushing	15.	Nut
8.	Clutch hub w/bushing	16.	5/8 NC x 3-1/2 Bolt

Figure 5. Slip Clutch Adjustment

CHAIN SHIELDING REPAIR

Inspect chain shielding frequently. Replace any broken or missing chains as required.

CLEANING

After Each Use

●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.

●Inspect machine and replace worn or damaged parts.

●Replace any safety decals that are missing or not readable.

Periodically or Before Extended Storage

●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.

●Remove the remainder using a low-pressure water spray.

1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.

2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.

3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.

●Inspect machine and replace worn or damaged parts.

●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).

●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.

29977 (Rev. 1/23/2009) Owner Service 19