Woods Equipment BW1620XQREV Gearbox Installation Figure, Splitter Gearbox Disassembly Figure

Gearbox Installation (Figure 11)

NOTE: Gearbox is heavy: do not attempt to move with- out mechanical assistance.

1.Set gearbox on cutter and fasten with bolts and nuts. Torque bolts to 300 lbs-ft.

2.Attach crossbar (Crossbar Installation, page 31).

SPLITTER GEARBOX REPAIR (Figure 12)

Splitter Gearbox Removal

1.Disconnect and remove all drivelines from gearbox.

2.Remove the four cap screws and lock washers that secure gearbox to cutter, and remove gearbox.

NOTE: Gearbox is heavy: do not attempt to move it without mechanical assistance.

Splitter Gearbox Disassembly (Figure 12)

Center Shaft

1.Remove plug from side of gearbox and pour out the gear oil.

2.Remove seal (6, to be replaced) from the front and rear of the center shaft (5).

3.Remove front cap (4) and gaskets (8, 9, 10) from the front and rear of the center shaft (5).

4.Support gearbox in a hand press and push on the rear of the center shaft.

5.Remove bearing cones (7), and gear (18) from center shaft (5).

6.Remove bearing cups (7) from housing and cap using a punch and hammer.

2.Lock washer, 10 mm

3.M10 x 1.5P x 30 Hex head cap screw

4.Input cap

5.Input shaft

6.Input oil seal

7.Bearing assembly (cup and cone)

8.Gasket .15 mm

9.Gasket .25 mm

10.Gasket .40 mm

11.Hub cap

12.Oil seal

13.Output shaft

14.Spacer

15.Shim .30 mm

16.Shim .40 mm

17.Shim .50 mm

18.Center gear

19.Wing gear

20.Bearing adjustment nut

21.1/8 x 2-1/2 Cotter pin

22.Sealing washer

23.M18 x 1.5P Level plug

24.M18 x 1.5P Breather plug

Figure 12. Splitter Gearbox Assembly

28 Dealer Service MAN0764 (11/5/2008)