Yazoo/Kees ZEKH42200, ZEKH48240, ZEKH52240 manual Personal Safety Equipment, Slope Operation

Page 11

SAFETY INSTRUCTIONS

Personal Safety Equipment

WARNING!

When using the machine, approved personal protective equipment (shown in illustrations) shall be used. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. Ask your retailer for help in choosing the right equipment.

Make sure that you have first aid equipment close at hand when using the machine.

• Never use the machine when barefoot. Always wear protective shoes or boots, preferably with steel toecaps.

Always wear approved protective glasses

or a full visor when assembling or driving.

Always wear gloves when handling the

blades.

Never wear loose clothing that can get caught

 

 

in moving parts.

 

Use ear protectors to avoid damage to

 

 

hearing.

8011-670

 

 

 

 

Personal protective equipment

Slope Operation

Slopes are a major factor related to loss of control and tip-over accidents, which can result in severe injury or death. Operation on all slopes requires extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it.

Mow up and down slopes (10 degrees maximum), not across.

Watch for holes, ruts, bumps, rocks, or other hidden objects. Uneven terrain could overturn the machine. Tall grass can hide obstacles.

Choose a low ground speed so that you will not have to stop while on the slope.

Do not mow on wet grass. Tires may lose traction.

Avoid starting, stopping, or turning on a slope. If the tires lose traction, disengage the blades and proceed slowly straight down the slope.

Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction, which could cause the machine to roll over.

6003-004

Mow up and down, not side-to-side

WARNING!

Do not drive up or down hills with slopes greater than 10 degrees. And do not drive across any slopes.

English-9

Image 11
Contents Operator’s manual Page OPERATOR’S Manual ZE Rider ContentsEnglish-2 Introduction IntroductionManufacturing Number Good ServiceXxxx xxxxxx Symbols and DecalsSymbols and Decals Repair work General Operation Safety InstructionsSafety Instructions English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Risk of sparking Important Information TransportCustomer responsibilities Controls ControlsMotion Control Levers Fuel Shut Off Valve Seat adjustment boltsParking Brake TrackingRefueling Fuses By pass linkageChoke Control Ignition SwitchHour Meter Throttle Control Blade switchUSE Full Throttle When Mowing , for Cutting height pedal AccessoriesTraining OperationOperation Starting the Engine Before StartingDepress the control for disengaging the mower deck Set the choke control USE Full Throttle When Mowing To remove cables, reverse order To start an engine with a weak batteryRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance Schedule MaintenanceMaintenance Nance Once Each Maintenance Before After 100 Always use protective glasses when handling the battery BatteryTo clean battery and terminals Replacing batteryIgnition System Checking the Safety System Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Standard air filter ServiceReplacing the Air Filter Checking Tire Pressures Replacing the Fuel FilterChecking the Fuel Pump’s Air Filter To replace deck belt Checking the Parking BrakeChecking the V-belts Deck beltDeck belt installation IZT belt removal IZT beltChecking the Blades Belt installationRemove blade bolt by turning counterclockwise Leveling Adjusting the Mower DeckAdjusting Cutting Height To adjust anti-scalp rollers Caster Wheels Cleaning and WashingUse protective glasses when cleaning and washing Removal and installation of caster wheelMower is tracking to the left Tracking adjustmentTo adjust parking brake Mower is tracking to the rightChange transaxles transmission filters LubricationLubrication Lubrication ScheduleFront Wheel Bearings Lubricating the CablesLubricating in Accordance with the Lubrication Schedule Front Wheel MountEngine Oil Changing the Engine Oil Deck outer spindleChecking the Oil Level Transaxle Transmission Fluid Change Changing the Engine Oil FilterExpansion Tank Purging Procedures Problem Cause Trouble Shooting GuideTrouble Shooting Guide English-60 English-61 Winter Storage ServiceStorage StorageWiring diagram Wiring DiagramsZEKH42200/968999694 ZEKH48240/968999698 Technical DataTechnical Data Productivity ZEKH52240/968999701 625 lbs Torque Specifications USA requirements Conformity CertificatesConformity Certificates Action Date, mtr reading, stamp, sign Service JournalService Journal Delivery ServiceAfter the First 5-8 Hours Action Hour ServiceEnglish-73 English-74 English-75 English-76 Page 530 131340IR 07/31/07