Yazoo/Kees ZEKH48240, ZEKH52240, ZEKH42200 manual Moving by Hand

OPERATION

Moving by Hand

When pushing or pulling the mower, be sure to engage the IZT (Integrated Zeroturn Transaxle) bypass linkages. The IZT bypass linkages are located on the rear of the frame, below the rear engine guard.

•Raise the deck into the highest cutting position.

•Release the park brake prior to engaging bypass linkages.

•Pull the IZT bypass linkages out and put them into the slots so that it is held in the bypass position.

•To re-engage the IZT’s to drive, reverse the above procedure.

•Load onto truck or trailer by driving up ramps in low gear. Do not lift! This machine is not intended to be lifted by hand,

CZ10-2

1.IZT Bypass linkage Bypass linkages

1

2

CZ12

1.Head outside of rear deck

2.IZT Bypass linkage in bypass position Bypass position

English-34