Yazoo/Kees ZEKH42200, ZEKH48240, ZEKH52240 Deck outer spindle, Engine Oil Changing the Engine Oil

LUBRICATION

4. Deck outer spindle

Lubricate using a grease gun, one zerk, each side 2-3 strokes.

Use only good quality bearing grease.

5. Engine Oil

Changing the Engine Oil

The engine oil should be changed for the first time after 5-8 hours of operation. Thereafter, it should be changed every 50 hours.

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool at least two (2) minutes.

1.Place the machine on a flat surface.

2.Place a container under the engine where the hose from the oil drain valve exits.

3.Remove the dipstick and open the drain valve.

4.Allow the oil to run out into the container.

5.Then close the oil drain valve.

6.Replace the oil filter if necessary.

7.Fill with new engine oil in accordance with Checking the Oil Level.

8.Start the engine. Run it for a few seconds. Stop and re-check the oil level.

8011-733

Deck outer spindle

IMPORTANT INFORMATION

Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.

Avoid skin contact; wash with soap and water in case of spills.

8011-730

Oil drain valve

English-54