CONTROLS
13. Cutting height pedal
The cutting deck height is obtained by pressing the foot pedal lift arm forward and releasing the transport latch. Then lower the deck to the preset height. To raise the deck push forward on the foot pedal lift arm until the transport latch locks. The cutting height range is from 1 1/2" (38 mm) to 4½"
(114 mm) in ¼" (6.4 mm) increments. The heights are measured from the ground up to the blade tip with the engine not running.
To change cutting heights move the pin on the cutting height plates to the desired height of cut.
IMPORTANT INFORMATION
In order to obtain an even cutting height it is important that the air pressure in all four tires is the same 15 psi (1 bar).
3 | 1 |
| |
| 2 |
1.Foot pedal
2.Lift arm
3.Height plate Cutting height pedal
Accessories
For mulching, there is a BioClip attachment available. This is mounted underneath the mower deck and consists of control plates and BioClip blades.