Multiquip LT12DAB Operation, Starting the Engine, Mast operation, Outriggers and Support Stands

Page 24

operation

Starting the Engine

1.Open the access panel door on the right side of the light tower (opposite the fuel tank). Set the door latch in place to hold the door open (up).

2.Ensure all breakers are off.

3.Insert the ignition key into the ignition key switch (Figure 14). Turn the ignition key clockwise one click to the ON position. The preheat indicator lamp will light. Wait for this indicator lamp to go OFF. When the indicator lamp goes OFF, the glow plugs have been preheated and the engine can now be started.

 

PREHEAT

 

INDICATOR

LOMBARDINI

LAMP

IGNITION

KEY

SWITCH

Figure 14. Ignition Key Switch (Lombardini/

Deutz Engine)

4.Continue turning the ignition key all the way clockwise When the engine has started, release the key.

5.Before placing the light tower into actual operation, let the engine run for 3-5 minutes. Check any abnormal sounds or smells that would be associated with a defective light tower. If any abnormal conditions occur, shut down the light tower and correct the problem.

mast operation

DANGER

ALWAYS make sure the area above light tower is open and clear of overhead power lines and other obstructions. The tower extends in excess of 30 feet (9 meters). Contact with overhead power lines or other obstructions could result in equipment damage, serious injury or death!

DANGER

DO NOT stand behind the trailer while the mast is being raised or lowered. Serious injury could result if the mast falls down.

Outriggers and Support Stands

See Figure 15 for location of components.

1.Make sure both outriggers are extended.To extend the outriggers, pull the locking pin on the outrigger and hold while sliding out the outrigger assembly.

PULL

ROTATE JACK

OUTRIGGER

STAND TO PLACE

TO EXTEND

IN SUPPORT

 

POSITION

TO RELEASE

 

OUTRIGGER

 

PULL PIN

 

OUTRIGGER

 

JACK STAND

Figure 15. Deploying Outriggers

page 24 — LT12Dab LIGHT TOWER • operation manual — rev. #0 (06/03/11)

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Model LT12DAB Table of Contents Specifications are subject to change without noticeSafety Information SaFeTY meSSageSSaFeTY SYmbOLS Addresses practices not related to personal injuryGeneRaL SaFeTY LIgHT TOWeR SaFeTY Lamp SaFeTYEngIne SaFeTY „ The engine of this equipment Requires an adequate freeFueL SaFeTY TOWIng SaFeTY„ neveR use fuel as a cleaning agent From fuel vapors or if fuel is spilled on a hot engineTRanSpORTIng SaFeTY Loading and Tie-Down on Flatbed TruckELeCTRICaL SaFeTY Power Cord/Cable SafetyGrounding Safety „ aLWaYS make sure the areaBaTTeRY SaFeTY EnvIROnmenTaL SaFeTYLamp footcandle plot Lamp Footcandle PlotLT12DAB Specifications Generator SpecificationsTrailer Specifications Engine Specifications Dimensions DimensionsReference Letter Description Dimension Length Mast Stowed Position Length Mast Deployed PositionGeneral information Metal Halide LampsConvenience Receptacle plates Components Major Components Control Panel SideView Controls and Indicators Control panelControl panel Indoor Installation InspectionBefore starting Engine Oil CheckBattery Check Wipe up any spilled fuel immediatelyCleaning the Radiator Air Cleaner Fan Belt TensionCoolant Operation in Freezing WeatherLocation of Female Connectors Operation Starting the EngineMast operation Outriggers and Support StandsDeploying the Mast to Vertical Position Raising the MastLowering the Mast Stowing the Mast to Horizontal PositionMast Operation Turning On the Lamps AUXILIARY Output ReceptaclesNormal Shutdown Emergency ShutdownMaintenance Basic Inspection and MaintenanceInspection/Maintenance FrequencyService Daily Air CleanerCleaning the Fuel Strainer General InspectionChanging Oil Replacing Fuel FilterCheck Cable Wear Servicingthe Mast Raise/Lower Cable SystemServicingthe Mast Extension Cable System Lower the mast to the horizontal resting positionStorage Removal From Long Term StorageMaintenance Trailers Adjustable ChannelWheel Hub Adjustment Leaf Suspension Leaf Suspension ComponentsGenerator Troubleshooting Symptom Possible Problem SolutionEngine Troubleshooting Symptom Possible Cause SolutionEngine revolution is not Lamp Troubleshooting When switch is first Checking voltage and ballast Turned on Replacement minimizes color differencesClean fixture Lamp starts slowly ARC does not strike Defective Lamp?Lamp Troubleshooting Guide ConnectionsStarting Ballast RemovalLight tower wiring diagram StatorWHT GRN BLK Lombardini engine wiring diagram Trailer guidelines COmmOn CauSeS for Loss of TRaILeRTRaILeR TOWIng guIDeLIneS „ Driving too fast for the conditions obey local speed lawsDRIvIng COnDITIOnS COupLIng to THe TOW veHICLeInOpeRabLe bRaKeS, LIgHTS or mIRRORS TRaILeR TOWIng TIpSTRaILeR vIn Tag ELeCTRICaL COnneCTOR TOW veHICLeSuSpenSIOn SYSTem SIDe vIeW mIRRORSSaFeTY CHaInS JaCKSTanDCOupLeR TYpeS Lock washer and hitch frame Coupling the Trailer to the Tow vehicle ball CouplerAttaching Safety Chain Connecting Trailer LightsUncoupling the ball Hitch PInTLe Hitch COupLeR Pintle Coupler and pintle HookTIRe SaFeTY Unsafe Tires, Lug nuts or Wheels Coupling Trailer to Tow vehicle pintle CouplerDetermining Load Limit of Trailer StepTighten lug nuts before each tow Be sure lug nuts are tight before each towDetermining Load Limit of Tow vehicle Step TIRe FunDamenTaLSP indicates the tire is for passenger vehicles Uniform Tire Quality grading Standards uTQgS Table a. Speed RatingLetter Rating Speed Rating Tire Safety Tips Table b. Tire Wear TroubleshootingTire Repair Replacing Worn or Damaged TiresLights and Signals Wheel RimsWheels, bearings and Lug nuts Lug nut Torque RequirementsFigure L. Trailer to Tow Vehicle Wiring Diagram HERE’S HOW to GET Help

LT12DAB specifications

The Multiquip LT12DAB is an innovative and reliable light tower designed to deliver efficient lighting solutions for various outdoor applications. Known for its robust construction and user-friendly features, the LT12DAB is ideal for construction sites, events, and emergency situations, providing flexibility and performance in a compact package.

One of the standout features of the LT12DAB is its powerful lighting system. It is equipped with four high-intensity LED lights, each delivering up to 12,000 lumens, ensuring ample illumination for expansive areas. The LED technology not only enhances visibility but also offers advantages in power consumption, resulting in reduced energy costs and longer operational life. The tower can be raised up to 30 feet, enabling it to cast a broad beam of light across large outdoor spaces.

The LT12DAB is built with advanced mobility in mind. It features a durable, weather-resistant frame that can withstand various environmental conditions, making it suitable for use in diverse locations. The all-terrain wheels provide enhanced maneuverability, allowing operators to transport the unit easily across job sites or uneven terrains. Additionally, the lightweight design ensures that it can be easily handled by a small crew.

Powering the LT12DAB is a reliable and fuel-efficient diesel generator that provides extended run times without frequent refueling. This generator not only supports the lighting system but can also power additional tools and equipment, adding versatility to its functionality. The unit is designed with low noise emissions, making it ideal for operation in noise-sensitive areas.

Ease of use is paramount in the design of the LT12DAB. The intuitive control panel allows users to operate the lights and generator effortlessly. The telescopic mast can be raised or lowered quickly, with safety features in place to prevent accidental collapse. Moreover, the integrated sensors monitor the oil levels and engine temperature, providing alerts for maintenance needs.

In summary, the Multiquip LT12DAB combines powerful lighting capabilities with robust construction and user-friendly features. Its mobility, energy efficiency, and reliability make it a valuable tool for any outdoor project, ensuring that worksites remain well-lit and safe, regardless of the conditions. Whether for construction, events, or emergencies, the LT12DAB stands out for its performance and adaptability, meeting the demands of today’s professional environments.
Top Page Image Contents