Henny Penny 500 Error Codes, Warnings And, ERROR MESSAGES Continued, Display, Cause, Correction

					Model 500/600
	3-5. WARNINGS AND
	ERROR MESSAGES (Continued)
		ERROR CODES
	DISPLAY	CAUSE	CORRECTION
	“E-41”	Memory scrambled; an individual	Turn the COOK/PUMP switch OFF and back
	“SYSTEM	product program may be scrambled;	to COOK; if error code persists, have the PC
	DATA LOST”	ex: “E-41 -2- DATA LOST”; this	board checked or re-initialized
		means product #2 program is
		scrambled
	“E-46”	Faulty eprom or PC board	Turn the COOK/PUMP switch OFF and back
	“DATA SAVE		to COOK; if error code persists, have the PC
	FAILED”		board checked or re-initialized
	“E-47”	Failure of 12 volt DC supply	Turn the COOK/PUMP switch OFF and back
	“ANALOG	on the I/O board	to COOK; if the	and	DO NOT
	SYSTEM
	OR 12 VOLT		light up when the 8888’s are displayed, have the
	FAILED”		I/O board replaced
		Amp sensors plugged in backwards	Have positions of amp sensors checked
		Faulty PC board	Have control panel replaced
	“E-48”	Failure of 12 volt DC supply	Turn the COOK/PUMP switch OFF and back
	INPUT	on the I/O board	to COOK; if the	and	DO NOT
	SYSTEM
	ERROR”		light up when the 8888’s are displayed, have the
			I/O board replaced
		Faulty PC board	Have control panel replaced
	“E-70 A”	Missing or broken wire in pins 1 and	Have jumper wire between pins 1 and 2
	“FAN VAC	2 of P11 connector, or faulty	checked
	JUMPER	connector
	MISSING”	Faulty I/O board	Have I/O board checked and replaced if
			necessary
	“E-70 B”	Faulty COOK/PUMP switch	Have COOKPUMP switch checked, along
	“PWR SW	or switch wiring; faulty	with its wiring; have I/O board checked
	OR WIRES	I/O board
	FAILED”
	“E-92”	Blown 24 volt controller fuse, or	Have the 14-pin cable connector checked or
	“24 VOLT	bad 14-pin cable connection	have the fryer checked for a short to ground in
	FUSE”		components such as the drain switch, solenoid,
			or high limit and wiring
		Stuck or clogged solenoid valve	Have solenoid checked and cleaned
205					3-13