Multiquip LT12DAB operation manual TRanSpORTIng SaFeTY, Loading and Tie-Down on Flatbed Truck

Page 8

Safety Information

TRanSpORTIng SaFeTY

CauTIOn

„Before lifting, make sure that light tower parts are not damaged and screws are not loosened or lost.

„aLWaYS make sure crane or lifting device has been properly secured to lifting hook of the equipment.

„neveR lift the equipment while engine is running.

„Make sure the tower is in the stowed position before lifting.

STOWED

POSITION

REAR

MAST

LOCK

„aLWaYS Make sure rear mast lock is secure before lifting.

„Use adequate lifting cable (wire or rope) of suffi cient strength.

„Use one point suspension hook and lift straight upwards.

LIFTING BALE

LIGHT TOWER

FORKLIFT

POCKETS

„If lifting through pockets, make sure forks of forklift are inserted in pockets as far as possible before lifting.

„Never allow any person or animal to stand underneath the equipment while lifting.

„DO nOT lift equipment to unnecessary heights.

Loading and Tie-Down on Flatbed Truck

NOTICE

„Before loading light tower to fl atbed truck, disconnect all four fl oodlight connectors and tie-wrap the cables against the T-bar to prevent damage to the cables and connectors.

CABLE

TIE

CABLE

CONNECTORS

DISCONNECTED

„When loading onto fl atbed truck, make sure that front jackstand of light tower is retracted and in the horizontal position so that the foot does not make contact with the deck fl oor.

FRONT JACKSTAND

RETRACTED

TONGUE

TRANSPORT

 

 

TIE-DOWN

 

POINT (4)

SIDE

REAR

JACK

JACK

STAND (2)

STAND (2)

„Make sure that the two side (left and right) and two rear jackstands are in the vertical postion, slightly extended, so that each foot makes contact with the deck fl oor.

„Straps and chains should be routed through the transport tie-down points located beneath each corner of the cabinet to allow even application of forece to the front and rear of the machine.

„DO nOT secure the unit by running a strap or chain over the tongue of the light tower. This may cause severe damage to the unit.

page 8 — LT12Dab LIGHT TOWER • operation manual — rev. #0 (06/03/11)

Image 8
Contents Model LT12DAB Table of Contents Specifications are subject to change without noticeSafety Information SaFeTY meSSageSSaFeTY SYmbOLS Addresses practices not related to personal injuryGeneRaL SaFeTY LIgHT TOWeR SaFeTY Lamp SaFeTYEngIne SaFeTY „ The engine of this equipment Requires an adequate freeFueL SaFeTY TOWIng SaFeTY„ neveR use fuel as a cleaning agent From fuel vapors or if fuel is spilled on a hot engineTRanSpORTIng SaFeTY Loading and Tie-Down on Flatbed TruckELeCTRICaL SaFeTY Power Cord/Cable SafetyGrounding Safety „ aLWaYS make sure the areaBaTTeRY SaFeTY EnvIROnmenTaL SaFeTYLamp footcandle plot Lamp Footcandle PlotTrailer Specifications LT12DAB SpecificationsGenerator Specifications Engine Specifications Dimensions DimensionsReference Letter Description Dimension Length Mast Stowed Position Length Mast Deployed PositionConvenience Receptacle plates General informationMetal Halide Lamps Components Major Components Control Panel SideView Controls and Indicators Control panelControl panel Indoor Installation InspectionBefore starting Engine Oil CheckBattery Check Wipe up any spilled fuel immediatelyCleaning the Radiator Air Cleaner Fan Belt TensionCoolant Operation in Freezing WeatherLocation of Female Connectors Operation Starting the EngineMast operation Outriggers and Support StandsDeploying the Mast to Vertical Position Raising the MastLowering the Mast Stowing the Mast to Horizontal PositionMast Operation Turning On the Lamps AUXILIARY Output ReceptaclesNormal Shutdown Emergency ShutdownMaintenance Basic Inspection and MaintenanceInspection/Maintenance FrequencyService Daily Air CleanerCleaning the Fuel Strainer General InspectionChanging Oil Replacing Fuel FilterCheck Cable Wear Servicingthe Mast Raise/Lower Cable SystemServicingthe Mast Extension Cable System Lower the mast to the horizontal resting positionStorage Removal From Long Term StorageWheel Hub Adjustment Maintenance TrailersAdjustable Channel Leaf Suspension Leaf Suspension ComponentsGenerator Troubleshooting Symptom Possible Problem SolutionEngine Troubleshooting Symptom Possible Cause SolutionEngine revolution is not Lamp Troubleshooting When switch is first Checking voltage and ballast Turned on Replacement minimizes color differencesClean fixture Lamp starts slowly ARC does not strike Defective Lamp?Lamp Troubleshooting Guide ConnectionsStarting Ballast RemovalLight tower wiring diagram StatorWHT GRN BLK Lombardini engine wiring diagram Trailer guidelines COmmOn CauSeS for Loss of TRaILeRTRaILeR TOWIng guIDeLIneS „ Driving too fast for the conditions obey local speed lawsDRIvIng COnDITIOnS COupLIng to THe TOW veHICLeTRaILeR vIn Tag InOpeRabLe bRaKeS, LIgHTS or mIRRORSTRaILeR TOWIng TIpS ELeCTRICaL COnneCTOR TOW veHICLeSuSpenSIOn SYSTem SIDe vIeW mIRRORSCOupLeR TYpeS SaFeTY CHaInSJaCKSTanD Lock washer and hitch frame Coupling the Trailer to the Tow vehicle ball CouplerUncoupling the ball Hitch Attaching Safety ChainConnecting Trailer Lights PInTLe Hitch COupLeR Pintle Coupler and pintle HookTIRe SaFeTY Unsafe Tires, Lug nuts or Wheels Coupling Trailer to Tow vehicle pintle CouplerDetermining Load Limit of Trailer StepTighten lug nuts before each tow Be sure lug nuts are tight before each towP indicates the tire is for passenger vehicles Determining Load Limit of Tow vehicle StepTIRe FunDamenTaLS Letter Rating Speed Rating Uniform Tire Quality grading Standards uTQgSTable a. Speed Rating Tire Safety Tips Table b. Tire Wear TroubleshootingTire Repair Replacing Worn or Damaged TiresLights and Signals Wheel RimsWheels, bearings and Lug nuts Lug nut Torque RequirementsFigure L. Trailer to Tow Vehicle Wiring Diagram HERE’S HOW to GET Help

LT12DAB specifications

The Multiquip LT12DAB is an innovative and reliable light tower designed to deliver efficient lighting solutions for various outdoor applications. Known for its robust construction and user-friendly features, the LT12DAB is ideal for construction sites, events, and emergency situations, providing flexibility and performance in a compact package.

One of the standout features of the LT12DAB is its powerful lighting system. It is equipped with four high-intensity LED lights, each delivering up to 12,000 lumens, ensuring ample illumination for expansive areas. The LED technology not only enhances visibility but also offers advantages in power consumption, resulting in reduced energy costs and longer operational life. The tower can be raised up to 30 feet, enabling it to cast a broad beam of light across large outdoor spaces.

The LT12DAB is built with advanced mobility in mind. It features a durable, weather-resistant frame that can withstand various environmental conditions, making it suitable for use in diverse locations. The all-terrain wheels provide enhanced maneuverability, allowing operators to transport the unit easily across job sites or uneven terrains. Additionally, the lightweight design ensures that it can be easily handled by a small crew.

Powering the LT12DAB is a reliable and fuel-efficient diesel generator that provides extended run times without frequent refueling. This generator not only supports the lighting system but can also power additional tools and equipment, adding versatility to its functionality. The unit is designed with low noise emissions, making it ideal for operation in noise-sensitive areas.

Ease of use is paramount in the design of the LT12DAB. The intuitive control panel allows users to operate the lights and generator effortlessly. The telescopic mast can be raised or lowered quickly, with safety features in place to prevent accidental collapse. Moreover, the integrated sensors monitor the oil levels and engine temperature, providing alerts for maintenance needs.

In summary, the Multiquip LT12DAB combines powerful lighting capabilities with robust construction and user-friendly features. Its mobility, energy efficiency, and reliability make it a valuable tool for any outdoor project, ensuring that worksites remain well-lit and safe, regardless of the conditions. Whether for construction, events, or emergencies, the LT12DAB stands out for its performance and adaptability, meeting the demands of today’s professional environments.