Homelite UT49102 manuel dutilisation General Maintenance, Lubrication, Replacing Hydraulic OIL

OPERATION

nTo stop the splitter, release both controls to return the ram to the starting position.

NOTE: If only one hand is removed from either the switch or the lever, the log splitter will freeze in place. When both the switch and the lever are released, the ram will return to the starting position.

splitting logs

See Figures 8 - 9.

Always place logs lengthwise on the work table and resting firmly on the side supports with one end against the wedge. Place logs flat and in the direction of the grain. Never angle the log to split it or place the log crosswise on the splitter. Never split more than one log at a time.

CAUTION:

Never keep pressure on the wood by trying to force the log splitter for more than five seconds. After five seconds, the oil will heat and can damage the tool.

nPlace log lengthwise and lying flat on the work table.

NOTE: If the log is small, place it against the wedge before starting the splitter.

nUsing the right hand, push down and hold the on/off switch.

nPush down and hold the hydraulic control lever with the left hand. With both the lever and the on/off switch acti- vated, the ram will push the log into the wedge and split the wood.

nOnce the log is split, release both controls to return the ram to the starting position.

freeing a jammed log

See Figures 10 - 11.

nRelease both controls.

nInsert a wood wedge under the jammed log after the ram is back at the starting position, .

nStart the log splitter to push the wood wedge completely under the jammed log.

nIf the log is still jammed, repeat the above steps as needed using a thicker angled wood wedge until the log is completely freed.

WARNING:

Never try to knock the jammed log off the splitter. Doing so may damage the tool or may cause the log to fly up and hit someone causing injury.

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses with side shields during tool operation. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, lubricant, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating lubricants, etc., come in con- tact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.

Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an Authorized Service Center.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.

REPLACING HYDRAULIC OIL

See Figures 12 - 13.

The hydraulic oil in the log splitter needs to be changed every 150 hours of use.

nUnplug the log splitter.

nPosition the log splitter so that the motor end is slightly higher than the oil drain plug.

nUsing an 8 mm hex key, remove the oil drain bolt.

nDrain the hydraulic oil from the oil tank into a four liter capacity container.

nOnce the oil has drained from the oil tank, turn the log splitter on the end with the wheels.

10 — English