TROUBLESHOOTING
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Engine will not start. | No spark. | Check spark. Remove spark plug. |
|
| Reattach the spark plug cap and lay |
|
| spark plug on metal cylinder. Pull the |
|
| starter rope and watch for spark at |
|
| spark plug tip. If there is no spark, |
|
| repeat test with a new spark plug. |
| No fuel. | Push primer bulb until bulb is full of |
|
| fuel. If bulb does not fill, primary fuel |
|
| delivery system is blocked. Contact |
|
| a servicing dealer. If primer bulb fills, |
|
| engine may be flooded, proceed to |
|
| next item. |
| Engine is flooded. | Remove spark plug, turn blower so |
|
| spark plug hole is aimed at the ground. |
|
| Set the choke lever to “RUN” position |
|
| and pull starter cord 10 to 15 times. |
|
| This will clear excess fuel from engine. |
|
| Clean and reinstall spark plug. Pull |
|
| starter three times with choke lever |
|
| on “RUN”. If engine does not start, set |
|
| choke lever to “FULL CHOKE” position |
|
| and repeat normal starting procedure. |
|
| If engine still fails to start, repeat |
|
| procedure with a new spark plug. |
| Starter rope pulls harder now than | Contact a servicing dealer. |
| when new. |
|
|
|
|
Engine starts but will not accelerate. | Engine requires approximately three | Allow engine to completely warm up. If |
| minutes to warm up. | engine does not accelerate after three |
|
| minutes, contact a servicing dealer. |
|
|
|
Engine starts but will only run at high | Carburetor requires adjustment. | Contact a servicing dealer. |
speed at half choke. |
|
|
|
|
|
Engine does not reach full speed and | Check lubricant fuel mixture. | Use fresh fuel and the correct |
emits excessive smoke. |
| lubricant mix. |
| Air filter is dirty. | Clean air filter. Refer to Cleaning |
|
| the Air Filter Screen earlier in this |
|
| manual. |
| Spark arrestor screen is dirty. | Contact a servicing dealer. |
|
|
|
Page 9 — English