Guardian Technologies 004708-0 ‹ 1.5.5 Generator, Fuel Consumption, Engine OIL Requirements

Page 8

Section 1 – General Information

Recreational Vehicle Generator

‹ 1.5.5 GENERATOR

The manufacturer does not recommend using any gasoline containing alcohol (such as “gaso- hol”). If using any gasoline containing alcohol, it must not contain more than 10 percent ethanol, and it must be removed from the generator dur- ing storage. Do NOT use any gasoline containing methanol. If using gasoline with alco- hol, inspect more frequently for fuel leaks and other abnormalities.

‹ 1.5.2

FUEL CONSUMPTION

 

 

 

 

 

 

 

Model

 

No Load

 

1/2 Load

Full Load

004700-0

 

0.24

 

0.35

0.55

004708-0

 

 

 

 

 

Fuel consumption is in gal/hr.

 

 

‹ 1.5.3

ENGINE OIL REQUIREMENTS

Use only high quality detergent oil rated with American Petroleum Institute (API) Service Classification SF, SG or SH. The recommended oil weights include the following:

During summer months: SAE 30. An acceptable substitute is SAE 10W-30.

During winter months: SAE 5W-30. DO NOT USE SAE 10-W40.

Crankcase and oil filter capacity is approximately 800 mL or .84 U.S. quarts. Do NOT use special addi- tives. See sections "Checking the Engine Oil Level" and "Changing the Engine Oil and/or Oil Filter" for oil level check and fill procedures.

Rated Maximum Continuous

 

AC Output (Gasoline)

3,600 Watts (3.6 kW)

Rated Voltage

120 Volts AC

Rated Maximum Continuous

 

AC Current (Gasoline)

30 Amperes

Phase

Single

Rotor RPM

3,600

Number of Rotor Poles

2

Engine RPM

3,600

Rated AC Frequency

60 Hz

Battery Charge Voltage

14 Volts DC

Battery Charge Current

2 Amperes (max)

Gasoline weight

170 Pounds

Length

749.8 mm (29.52 in.)

Width

483.1 mm (19.02 in.)

Height

342.2 mm (13.47 in.)

‹1.5.6 EMISSIONS COMPLIANCE PERIOD

For non-handheld engines the Emissions Compliance Period referred to on the Emissions Compliance Label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements.

For engines less than 225 cc displacement, Category C=125 hours, B=250 hours, and A=500 hours.

For engines of 225 cc or more, Category C=250 hours, B=500 hours, and A=1000 hours.

‹1.5.4 ENGINE

Type of Engine

GN-220, Single-cylinder

Cooling Method

Air-cooled

Rated Horsepower

7.8 @ 4,200 rpm

Displacement

220cc

Cylinder Block

Aluminum w/Cast Iron Sleeve

Type of Governor

Mechanical, Fixed Speed

Air Cleaner

Paper Element w/Foam Precleaner

Starter

12-volt DC Electric

Ignition System

Solid-state w/Flywheel Magneto

Recommended Spark Plug

 

Champion

RC14YC

AC

R45S

Fram Autolite

65

Spark Plug Gap

0.030 inch (76 mm)

Recommended Minimum Battery

400 Cold-cranking

 

 

Amperes

6

Image 8
Contents Air-cooled Recreational Vehicle Generators Authorized Service Dealer Location IntroductionPart II Installation Instructions Part Warning   Fire Hazards  Generator Identification Model Number Serial Number KW Rating Rated VoltageSafety SpecificationsGenerator Applicability ‹ 1.5.1 Fuel Requirements‹ 1.5.5 Generator Fuel ConsumptionEngine OIL Requirements ‹ 1.5.6 Emissions Compliance PeriodBefore Starting the Engine Generator Control PanelAutomatic Choke Starting the Generator ‹ 2.4.2 Engine Lubrication‹ 2.4.3 Fuel Supply ‹ 2.4.4 Cooling and Ventilating AIRDo not Overload the Generator Protection Systems Stopping the GeneratorApplying Loads to Generator Additional Information ‹ 2.9.3 Field Boost‹ 2.10.2 Operation in High Grass or Brush ‹ 2.9.4 Overvoltage ProtectionChecking the Engine OIL Level Changing the Engine OIL AND/OR OIL Filter‹ 3.3.1 Cleaning the Foam Precleaner Maintaining the Engine AIR CleanerClean AIR Intake Fuel Filter Clean Spark ArrestorCleaning the Generator Battery Maintenance OUT of Service Procedure‹ 3.12.1 Removal from Service Exercising the Generator‹ 3.12.2 Return to Service Adjusting Valve ClearanceRV Generator Service Interval Recreational Vehicle Generator Part  General Hazards   Fire Hazards  Standards Booklets Purpose and Scope ManualEquipment Description Major Features and Dimensions Drawing No D8716-H ‹ 2.1.2 Generator Support Location and Support‹ 2.1.1 Generator Location Generator Compartments ‹ 2.1.4 Generator Restraint‹ 2.2.2 Compartment Construction ‹ 2.2.1 Compartment Size‹ 2.2.4 Acoustics ‹ 2.2.3 Sound Insulating Materials‹ 2.2.5 Compartment Floor Cutouts ‹ 2.3.1 Generator AirflowCompartment Floor Cutout Drawing 0G3723-A ‹ 2.3.2 Testing the Installation Gasoline Fuel System‹ 2.4.1 Fuel Tank ‹ 2.4.2 Generator Fuel Supply Line‹ 2.5.1 Spark Arrestor Exhaust SystemFlexible Fuel Line ‹ 2.5.2 Exhaust System Safety Electrical Connections‹ 2.6.4 Conduit ‹ 2.6.5 Isolating Different Power Sources‹ 2.6.6 Power Supply Cord ‹ 2.7.2 Battery Cables Battery Installation‹ 2.7.1 Recommended Battery ‹ 2.8.1 Remote START/STOP Panel Optional Accessories‹ 2.7.4 Battery Compartment Post Installation Tests Testing Under LoadBefore Initial START-UP Initial StartInstallation Checklist Troubleshooting Guide Problem Cause CorrectionElectrical Data Customer Supplied by Recreational Vehicle Generator Enclosure Drawing No D8352-M QTY Description Recreational Vehicle Generator Generator Drawing No D8353-M FAN, 8 Curve BLADE, 16.5MM I.D Exploded Views and Parts Lists QTY Exploded Views and Parts Lists GUARD, FAN Exploded Views and Parts Lists Long Block Assembly PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Control System Warranty Emission Related Parts Include the FollowingWarranty Schedule CONSUMER/PERSONAL Applications