Guardian Technologies 004700-0, 004708-0 owner manual  Fire Hazards 

Page 5

Safety Rules

When working on this equipment, remain alert at all times. Never work on the equipment when physically or mentally fatigued.

Inspect the generator regularly, and contact the nearest Authorized Service Dealer immediately for parts needing repair or replacement.

Before performing any maintenance on the gen- erator, disconnect its battery cables to prevent accidental start up. Disconnect the cable from the battery post indicated by a NEGATIVE, NEG or (–) first. Reconnect that cable last.

Never use the generator or any of its parts as a step. Stepping on the unit can stress and break parts, and may result in dangerous operating con- ditions from leaking exhaust gases, fuel leakage, oil leakage, etc.

Recreational Vehicle Generator

FIRE HAZARDS

For fire safety, the generator must be installed and maintained properly. Installation always must comply with applicable codes, standards, laws and regulations. Adhere strictly to local, state and national electrical and building codes. Comply with regulations the Occupational Safety and Health Administration (OSHA) has established. Also, ensure that the generator is installed in accordance with the manufacturer’s instructions and recommendations. Following proper installa- tion, do nothing that might alter a safe installation and render the unit in noncompliance with the aforementioned codes, standards, laws and regu- lations.

ELECTRICAL HAZARDS

The generator covered by this manual produces dangerous electrical voltages and can cause fatal electrical shock. Avoid contact with bare wires, ter- minals, connections, etc., while the unit is running. Ensure all appropriate covers, guards and barriers are in place before operating the generator. If work must be done around an operating unit, stand on an insulated, dry surface to reduce shock hazard.

Do not handle any kind of electrical device while standing in water, while barefoot, or while hands or feet are wet. DANGEROUS ELECTRICAL SHOCK MAY RESULT.

During installation onto the vehicle, have the generator properly grounded (bonded) either by solid mounting to the vehicle frame or chassis, or by means of an approved bonding conductor. DO NOT disconnect the bonding conductor, if so equipped. DO NOT reconnect the bonding conduc- tor to any generator part that might be removed or disassembled during routine maintenance. If the grounding conductor must be replaced, use only a flexible conductor that is of No. 8 American Wire Gauge (AWG) copper wire minimum.

In case of accident caused by electric shock, imme- diately shut down the source of electrical power. If this is not possible, attempt to free the victim from the live conductor. AVOID DIRECT CONTACT WITH THE VICTIM. Use a nonconducting imple- ment, such as a rope or board, to free the victim from the live conductor. If the victim is uncon- scious, apply first aid and get immediate medical help.

Never wear jewelry when working on this equip- ment. Jewelry can conduct electricity resulting in electric shock, or may get caught in moving com- ponents causing injury.

Keep a fire extinguisher in the vehicle at all times. Extinguishers rated “ABC” by the National Fire Protection Association are appropriate for use on the recreational vehicle generator electrical sys- tem. Keep the extinguisher properly charged and be familiar with its use. If there are any questions pertaining to fire extinguishers, consult the local fire department.

EXPLOSION HAZARDS

Do not smoke around the generator. Wipe up any fuel or oil spills immediately. Ensure that no com- bustible materials are left in the generator com- partment, or on or near the generator, as FIRE or EXPLOSION may result. Keep the area surround- ing the generator clean and free from debris.

Gasoline is extremely FLAMMABLE and its vapors are EXPLOSIVE. Do not permit smoking, open flame, sparks or any source of heat in the vicinity while handling gasoline. Comply with all laws gov- erning the storage and handling of gasoline.

3

Image 5
Contents Air-cooled Recreational Vehicle Generators Introduction Authorized Service Dealer LocationPart Part II Installation Instructions Warning   Fire Hazards  Model Number Serial Number KW Rating Rated Voltage Generator IdentificationSpecifications SafetyGenerator Applicability ‹ 1.5.1 Fuel RequirementsFuel Consumption ‹ 1.5.5 GeneratorEngine OIL Requirements ‹ 1.5.6 Emissions Compliance PeriodBefore Starting the Engine Generator Control PanelAutomatic Choke ‹ 2.4.2 Engine Lubrication Starting the Generator‹ 2.4.3 Fuel Supply ‹ 2.4.4 Cooling and Ventilating AIRDo not Overload the Generator Protection Systems Stopping the GeneratorApplying Loads to Generator ‹ 2.9.3 Field Boost Additional Information‹ 2.10.2 Operation in High Grass or Brush ‹ 2.9.4 Overvoltage ProtectionChanging the Engine OIL AND/OR OIL Filter Checking the Engine OIL Level‹ 3.3.1 Cleaning the Foam Precleaner Maintaining the Engine AIR CleanerClean AIR Intake Fuel Filter Clean Spark ArrestorCleaning the Generator OUT of Service Procedure Battery Maintenance‹ 3.12.1 Removal from Service Exercising the Generator‹ 3.12.2 Return to Service Adjusting Valve ClearanceRV Generator Service Interval Recreational Vehicle Generator Part  General Hazards   Fire Hazards  Standards Booklets Purpose and Scope ManualEquipment Description Major Features and Dimensions Drawing No D8716-H ‹ 2.1.2 Generator Support Location and Support‹ 2.1.1 Generator Location ‹ 2.1.4 Generator Restraint Generator Compartments‹ 2.2.2 Compartment Construction ‹ 2.2.1 Compartment Size‹ 2.2.3 Sound Insulating Materials ‹ 2.2.4 Acoustics‹ 2.3.1 Generator Airflow ‹ 2.2.5 Compartment Floor CutoutsCompartment Floor Cutout Drawing 0G3723-A Gasoline Fuel System ‹ 2.3.2 Testing the Installation‹ 2.4.1 Fuel Tank ‹ 2.4.2 Generator Fuel Supply Line‹ 2.5.1 Spark Arrestor Exhaust SystemFlexible Fuel Line Electrical Connections ‹ 2.5.2 Exhaust System Safety‹ 2.6.4 Conduit ‹ 2.6.5 Isolating Different Power Sources‹ 2.6.6 Power Supply Cord ‹ 2.7.2 Battery Cables Battery Installation‹ 2.7.1 Recommended Battery ‹ 2.8.1 Remote START/STOP Panel Optional Accessories‹ 2.7.4 Battery Compartment Testing Under Load Post Installation TestsBefore Initial START-UP Initial StartInstallation Checklist Problem Cause Correction Troubleshooting GuideElectrical Data Customer Supplied by Recreational Vehicle Generator Enclosure Drawing No D8352-M QTY Description Recreational Vehicle Generator Generator Drawing No D8353-M FAN, 8 Curve BLADE, 16.5MM I.D Exploded Views and Parts Lists QTY Exploded Views and Parts Lists GUARD, FAN Exploded Views and Parts Lists Long Block Assembly PURCHASER’S/OWNER’S Warranty Responsibilities Your Warranty Rights and ObligationsMANUFACTURER’S Emission Control System Warranty Coverage Emission Related Parts Include the Following Emission Control System WarrantyWarranty Schedule CONSUMER/PERSONAL Applications