8Lower the plastic securing lever.
9Connect any cables that should be attached to the card.
See the documentation that came with the card for information about the card cable connections.
10Close the computer cover (see page 90).
11Connect your computer and devices to their electrical outlets, and turn them on.
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.
12Install any drivers required for the card as described in the documentation that came with the card.
Removing Cards
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions listed in "When Working Inside Your Computer" on page 12.
1Shut down the computer (see page 20).
2Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4Open the computer cover (see page 67).
5If necessary, disconnect any cables connected to the card.
6To raise the securing lever, press the tab until it is free from the latch and then lift the lever.
Adding Parts
73