AGP card
card clip lever
AGP card clip
slot connector | back of computer |
Adding a Second Hard Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions listed in "When Working Inside Your Computer" on page 12.
Your computer includes one hard drive. To add a second hard drive:
1Shut down the computer (see page 20).
2Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4Unpack the drive and prepare it for installation.
See the drive documentation to ensure that the drive is set up for your computer.
5Open the computer cover (see page 67).
Adding Parts
81