NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4Open the computer cover (see page 67).
5Locate jumper PSWD on the system board (see page 70) and remove the jumper plug.
6Close the computer cover (see page 90), plug your computer into an electrical outlet, and turn on the computer.
This process erases the existing password(s).
7Shut down the computer (see page 20).
8Turn off any attached devices and disconnect them from their electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
9Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
10Open the computer cover (see page 67).
11Reinstall the PSWD jumper plug on pins 2 and 3 (pin 1 is marked on the system board).
12Close the computer cover (see page 90), plug your computer into an electrical outlet, and turn on the computer.
Turning on your computer with the PSWD jumper installed reenables the password feature.
Replacing the Battery
A
If you have to repeatedly reset time and date information after turning on the computer, replace the battery.
Appendix
99