Bush Hog RMB 1445 manual Dealer Setup Instructions, Stabilizer Attachment

Page 47

ASSEMBLY

DEALER SETUP INSTRUCTIONS

1.The machine is delivered in a partially assembled. To make ready for attachment to the tractor it will be necessary to select a hard level surface

2.Cut the banding straps and remove loose items and the stabilizer. Leave the transport straps on at this stage.

STABILIZER ATTACHMENT

Fit the stabilizer nose into the tractors top link position (A). Use the highest position available, avoiding any load sensing properties. The bolt on nose of the stabilizer is reversible to accommodate a variety of tractor linkage designs.

Stretch out the stabilizer and bolt to the machine using the holes farthest from the tractor that the stabilizer will reach (B). Do not fully tighten bolts at this stage and do not replace the stabilizer nose quadrant pin. (Figure ASM-B-0085)

RMB 1445 11/10

Assembly Section 3-5

© 2010 Alamo Group Inc.

ASSEMBLY

Image 47
Contents RMB To the Owner/Operator/Dealer Warranty InformationPage Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Hydraulic Hoses Page Safety Section Safety Operator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices Safety Stop Mowing if Passersby are Within 300 Feet Unless Safety SGM-06 SGM-08 Maintenance and Service Safety Instructions and Practices Safety Parts Information Transporting Safety Instructions and PracticesSafety Concluding Safety Instructions and Practices Decal Location Booklet NFS Serial PlateName LogoNFS SER PLT InstructMULTI-DECAL Decal Description Safety Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Tractor Preparation Installing the Operator Guard Cab TractorFactors that affect stability BallastStabilizer Attachment Dealer Setup InstructionsTOP Link Attachment Driveline Attachment Hose Routing Remove Transport StrapISO VG SAE Final Assembly ChecksOIL Requirements TankGearbox Fitting Control Unit in CABRMB 1445/1660/1865 With Flail Head only Running UP ProcedureRemoval from Tractor Page Operation Section Operation Operation Personal Protective Equipment PPE Operator RequirementsOperator Thrown Object Protection Tractor RequirementsRops and Seat Belt Tractor Ballast Tractor Lighting and SMV Emblem3-Point Hitch Tractor Safety DevicesTractor Horsepower Front End WeightGetting on and OFF the Tractor Power Take Off PTODismounting the Tractor Boarding the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/Service Boom Unit Pre-Operation Inspection and Service Hydraulic Line Inspection Frame AssemblyBoom ARM Assembly Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Implement Do not Operate an Unsafe Tractor or Mower Machine Controls Reversing Rotation With Flailhead Rotor ControlsRotor Operating Speed Angle FloatEngaging Drive Parallel Motion Geometry Forward SpeedTractor Position Operating SpeedHigh Voltage Cables Breakaway ActionCutting Sequence Grass Cutting Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Driving the Tractor and Boom Operating the Tractor and ImplementOperating Instructions RMB 1445 11/10 Operation Section Foreign Debris Hazards Bystanders/Passersby PrecautionsEngaging the Power Take Off PTO Operating the Mower Operating Speed and Ground SpeedSGM-08 Sickle Bar Operating the Attached Mower HeadsGrass Flail Shutting Down the Attached Head TRACTOR, BOOM, and Attached Head StorageTransporting the Tractor and Implement Transporting on Public Roadways Operation Hauling the Tractor and Implement Operation Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section Lubrication MaintenancePTO Lubrication PTO ShaftCutting PTO Shaft Maintenance Hydraulic Hoses Filtration MaintenanceHose Replacement Hydraulic SystemPTO Gearbox Hose WarrantyCables FlailheadMain Control Valve Hose ConnectionsProper Torque Values for Fasteners Maintenance Page Limited Warranty Required of the Operator Required of the OwnerRMB 1445 Rear Mount Boom Mower