Bush Hog RMB 1445 manual Foreign Debris Hazards, Bystanders/Passersby Precautions

Page 87

OPERATION

11.1 Foreign Debris Hazards

Before mowing, inspect the area to make sure there are no foreign objects that the mower blades could hit or become entangled with. Remove all foreign objects and debris. If objects are too big to remove, mark them clearly and be sure to prevent the mower blades from contacting them.

If you hit a solid object or foreign debris, stop the mower and tractor at once. Immediately idle the engine speed and disengage the PTO. Wait for all mower rotating motion to stop, then raise the mower and move the tractor and implement off the object. Inspect the area and remove, or mark the location of the debris. Inspect the condition of the mower and make any needed repairs immediately. Make sure the blades are not damaged and the carrier is balanced before resuming operation.

Always wear your seat belt securely fastened and only operate the tractor and mower with the ROPS in the raised position. If the tractor or mower hits a tree stump, rock, or bump, a sudden movement could throw you off of the seat and under the tractor and/or mower. The seat belt is your best protection from falling off the tractor and the ROPS provides protection from being crushed during a tractor roll-over. OPS-F-0010

11.2 Bystanders/Passersby Precautions

If a bystander comes within 300 feet of the tractor while the mower is being operated, stop the tractor at once, idle the engine and disengage the PTO. Do not engage the PTO again until all bystanders are well past the 300 foot distance. OPS-R-0024

RMB 1445 11/10

Operation Section 4-33

© 2010 Alamo Group Inc.

OPERATION

Image 87
Contents RMB To the Owner/Operator/Dealer Warranty InformationPage Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Hydraulic Hoses Page Safety Section Safety Operator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices Safety Stop Mowing if Passersby are Within 300 Feet Unless Safety SGM-06 SGM-08 Maintenance and Service Safety Instructions and Practices Safety Parts Information Transporting Safety Instructions and PracticesSafety Concluding Safety Instructions and Practices Decal Location Booklet NFS Serial PlateName LogoNFS SER PLT InstructMULTI-DECAL Decal Description Safety Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Tractor Preparation Installing the Operator Guard Cab TractorFactors that affect stability BallastStabilizer Attachment Dealer Setup InstructionsTOP Link Attachment Driveline Attachment Hose Routing Remove Transport StrapISO VG SAE Final Assembly ChecksOIL Requirements TankGearbox Fitting Control Unit in CABRunning UP Procedure Removal from TractorRMB 1445/1660/1865 With Flail Head only Page Operation Section Operation Operation Personal Protective Equipment PPE Operator RequirementsTractor Requirements Rops and Seat BeltOperator Thrown Object Protection Tractor Ballast Tractor Lighting and SMV Emblem3-Point Hitch Tractor Safety DevicesTractor Horsepower Front End WeightGetting on and OFF the Tractor Power Take Off PTODismounting the Tractor Boarding the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/Service Boom Unit Pre-Operation Inspection and Service Frame Assembly Boom ARM AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Implement Do not Operate an Unsafe Tractor or Mower Machine Controls Reversing Rotation With Flailhead Rotor ControlsAngle Float Engaging DriveRotor Operating Speed Parallel Motion Geometry Forward SpeedTractor Position Operating SpeedHigh Voltage Cables Breakaway ActionCutting Sequence Grass Cutting Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Driving the Tractor and Boom Operating the Tractor and ImplementOperating Instructions RMB 1445 11/10 Operation Section Foreign Debris Hazards Bystanders/Passersby PrecautionsEngaging the Power Take Off PTO Operating the Mower Operating Speed and Ground SpeedSGM-08 Operating the Attached Mower Heads Grass FlailSickle Bar Shutting Down the Attached Head TRACTOR, BOOM, and Attached Head StorageTransporting the Tractor and Implement Transporting on Public Roadways Operation Hauling the Tractor and Implement Operation Trouble Possible Cause Possible Remedy Troubleshooting GuideOperation Operation Maintenance Section Lubrication MaintenancePTO Lubrication PTO ShaftCutting PTO Shaft Maintenance Hydraulic Hoses Filtration MaintenanceHose Replacement Hydraulic SystemPTO Gearbox Hose WarrantyCables FlailheadHose Connections Proper Torque Values for FastenersMain Control Valve Maintenance Page Limited Warranty Required of the Operator Required of the OwnerRMB 1445 Rear Mount Boom Mower