Bush Hog RMB 1445 manual SGM-08

Page 90
(SGM-11)

OPERATION

OPERATION

There are obvious and hidden potential hazards in the operation of this Mower. REMEMBER! This machine is often operated in heavy brush and in heavy weeds. The Blades of this Mower can throw objects if shields are not properly installed and maintained. Serious injury or even death may occur unless care is taken to insure the safety of the operator, bystanders, or passersby in the area. Do not operate this machine with anyone in the immediate area. Stop mowing if anyone is within 300 feet of mower. (SGM-02)

Do not mow with two machines in the same area except with Cab tractors with the windows closed.

Mow only in conditions where you have clear visibility in daylight or with adequate artificial lighting. Never mow in darkness or foggy conditions where you cannot clearly see at least 300 feet (90 m) in front and to the sides of the tractor and mower. Make sure that you can clearly see and identify passersby, steep slopes, ditches, drop-offs, overhead obstructions, power lines, debris and foreign objects. If you are unable to clearly see these type of items discontinue mowing. (SGM-1)

Avoid mowing in reverse direction when possible. Check to make sure there are no persons behind the mower and use extreme care when mowing in reverse. Mow only at a slow ground speed where you can safely operate and control the tractor and mower. Never mow an area that you have not inspected and removed debris or foreign material.

(SGM-08)

Follow these guidelines to reduce the risk of equipment and grass fires while operating, servicing, and repairing the Mower and Tractor:

-Equip the Tractor with a fire extinguisher in an accesible location.

-Do Not operate the Mower on a Tractor with an underframe exhaust. -Do Not smoke or have an open flame near the Mower and Tractor. -Do Not drive into burning debris or freshly burnt areas.

-Ensure slip clutches are properly adjusted to prevent excessive slippage and plate heating.

-Never allow clippings or debris to collect near drivelines, slip clutches, and gearboxes. Periodically shut down the Tractor and Mower and clean clippings and collected debris from the mower deck. (SGM-12)

RMB 1445 11/10

Operation Section 4-36

© 2010 Alamo Group Inc.

Image 90
Contents RMB Warranty Information To the Owner/Operator/DealerPage Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Hydraulic Hoses Page Safety Section Safety Operator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices Safety Stop Mowing if Passersby are Within 300 Feet Unless Safety SGM-06 SGM-08 Maintenance and Service Safety Instructions and Practices Safety Transporting Safety Instructions and Practices Parts InformationSafety Concluding Safety Instructions and Practices Decal Location Logo NFS Serial PlateName BookletInstruct NFS SER PLTMULTI-DECAL Decal Description Safety Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Installing the Operator Guard Cab Tractor Tractor PreparationBallast Factors that affect stabilityDealer Setup Instructions Stabilizer AttachmentTOP Link Attachment Driveline Attachment Remove Transport Strap Hose RoutingTank Final Assembly ChecksOIL Requirements ISO VG SAEFitting Control Unit in CAB GearboxRunning UP Procedure Removal from TractorRMB 1445/1660/1865 With Flail Head only Page Operation Section Operation Operation Operator Requirements Personal Protective Equipment PPETractor Requirements Rops and Seat BeltOperator Thrown Object Protection Tractor Lighting and SMV Emblem Tractor BallastFront End Weight Tractor Safety DevicesTractor Horsepower 3-Point HitchPower Take Off PTO Getting on and OFF the TractorBoarding the Tractor Dismounting the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/Service Boom Unit Pre-Operation Inspection and Service Frame Assembly Boom ARM AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Implement Do not Operate an Unsafe Tractor or Mower Machine Controls Rotor Controls Reversing Rotation With FlailheadAngle Float Engaging DriveRotor Operating Speed Operating Speed Forward SpeedTractor Position Parallel Motion GeometryBreakaway Action High Voltage CablesCutting Sequence Grass Cutting Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Operating the Tractor and Implement Driving the Tractor and BoomOperating Instructions RMB 1445 11/10 Operation Section Bystanders/Passersby Precautions Foreign Debris HazardsEngaging the Power Take Off PTO Operating Speed and Ground Speed Operating the MowerSGM-08 Operating the Attached Mower Heads Grass FlailSickle Bar TRACTOR, BOOM, and Attached Head Storage Shutting Down the Attached HeadTransporting the Tractor and Implement Transporting on Public Roadways Operation Hauling the Tractor and Implement Operation Troubleshooting Guide Trouble Possible Cause Possible RemedyOperation Operation Maintenance Section Maintenance LubricationPTO Shaft PTO LubricationCutting PTO Shaft Maintenance Hydraulic System Filtration MaintenanceHose Replacement Hydraulic HosesHose Warranty PTO GearboxFlailhead CablesHose Connections Proper Torque Values for FastenersMain Control Valve Maintenance Page Limited Warranty Required of the Owner Required of the OperatorRMB 1445 Rear Mount Boom Mower