Bush Hog RMB 1445 manual Starting the Tractor

Page 64
(SG-34)
(SG-23)

OPERATION

OPERATION

5. STARTING THE TRACTOR

The operator must have a complete understanding of the placement, function, and operational use of all tractor controls before starting the tractor. Review the tractor operator’s manual and consult an authorized dealer for tractor operation instructions if needed.

Essential Tractor Controls:

Locate the ignition key/switch

Locate the engine shut off control

Locate the hydraulic control levers

Locate the light control lever

Locate the brake pedals and clutch

Locate the PTO control

Locate the 3 point hitch control lever

Locate the boom operating controls (joystick or valve bank)

Before starting the tractor ensure the following:

Conduct all pre-start operation inspection and service according to the tractor operator’s manual.

Make sure all guards, shields, and other safety devices are securely in place.

The parking brake is on.

The tractor transmission levers are in park or neutral.

The boom operating controls are in the neutral and off position.

The PTO control lever is disengaged.

The hydraulic remote control levers are in the neutral position.

Refer to the tractor owner’s manual for tractor starting procedures. Only start the tractor while seated and belted in the tractor operator’s seat. Never bypass the ignition switch by short circuiting the starter solenoid. After the tractor engine is running, avoid accidental contact with the tractor transmission to prevent sudden and unexpected tractor movement. OPS-B- 0003

Never run the Tractor engine in a closed building or without adequate ventilation. The exhaust fumes can be hazardous to your health.

Avoid contact with hot surfaces including hydraulic oil tanks, pumps, motors, valves and hose connections. Relieve hydraulic pressure before performing maintenance or repairs. Use gloves and eye protection when servicing hot components. Contact with a hot surface or fluid can cause serious injury from burns or scalding.

Always shut the Tractor completely down, place the transmission in park, and set the parking brake before you or anyone else attempts to connect or disconnect the Implement and Tractor hitches. (S3PT-15)

RMB 1445 11/10

Operation Section 4-10

© 2010 Alamo Group Inc.

Image 64
Contents RMB Warranty Information To the Owner/Operator/DealerPage Alamo Group Ag. Division is willing to provide Table of Contents Maintenance Section Hydraulic Hoses Page Safety Section Safety Operator Safety Instructions and Practices SG-36 Wait a minute...Save a life Equipment Operation Safety Instructions and Practices Safety Stop Mowing if Passersby are Within 300 Feet Unless Safety SGM-06 SGM-08 Maintenance and Service Safety Instructions and Practices Safety Transporting Safety Instructions and Practices Parts InformationSafety Concluding Safety Instructions and Practices Decal Location NFS Serial Plate NameLogo BookletInstruct NFS SER PLTMULTI-DECAL Decal Description Safety Safety Safety Safety Safety Safety Safety Federal Laws and Regulations Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Tractor Selection Installing the Operator Guard Cab Tractor Tractor PreparationBallast Factors that affect stabilityDealer Setup Instructions Stabilizer AttachmentTOP Link Attachment Driveline Attachment Remove Transport Strap Hose RoutingFinal Assembly Checks OIL RequirementsTank ISO VG SAEFitting Control Unit in CAB GearboxRemoval from Tractor Running UP ProcedureRMB 1445/1660/1865 With Flail Head only Page Operation Section Operation Operation Operator Requirements Personal Protective Equipment PPERops and Seat Belt Tractor RequirementsOperator Thrown Object Protection Tractor Lighting and SMV Emblem Tractor BallastTractor Safety Devices Tractor HorsepowerFront End Weight 3-Point HitchPower Take Off PTO Getting on and OFF the TractorBoarding the Tractor Dismounting the TractorStarting the Tractor PRE-OPERATION Inspection and Service Tractor Pre-Operation Inspection/Service Boom Unit Pre-Operation Inspection and Service Boom ARM Assembly Frame AssemblyHydraulic Line Inspection Hydraulic PUMP/OIL Reservoir Flail Head Inspection Sickle BAR Inspection Do not Operate an Unsafe Tractor or Implement Do not Operate an Unsafe Tractor or Mower Machine Controls Rotor Controls Reversing Rotation With FlailheadEngaging Drive Angle FloatRotor Operating Speed Forward Speed Tractor PositionOperating Speed Parallel Motion GeometryBreakaway Action High Voltage CablesCutting Sequence Grass Cutting Driving the Tractor and Implement Starting the Tractor Brake and Differential Lock Setting Operating the Tractor and Implement Driving the Tractor and BoomOperating Instructions RMB 1445 11/10 Operation Section Bystanders/Passersby Precautions Foreign Debris HazardsEngaging the Power Take Off PTO Operating Speed and Ground Speed Operating the MowerSGM-08 Grass Flail Operating the Attached Mower HeadsSickle Bar TRACTOR, BOOM, and Attached Head Storage Shutting Down the Attached HeadTransporting the Tractor and Implement Transporting on Public Roadways Operation Hauling the Tractor and Implement Operation Troubleshooting Guide Trouble Possible Cause Possible RemedyOperation Operation Maintenance Section Maintenance LubricationPTO Shaft PTO LubricationCutting PTO Shaft Maintenance Filtration Maintenance Hose ReplacementHydraulic System Hydraulic HosesHose Warranty PTO GearboxFlailhead CablesProper Torque Values for Fasteners Hose ConnectionsMain Control Valve Maintenance Page Limited Warranty Required of the Owner Required of the OperatorRMB 1445 Rear Mount Boom Mower